Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

Two have 3240 stamped on them (33" long), and two others have 2640 stamped on them (27" long)They are all 1/2" wide.I need to order 6 of each.

The code on my channel is "26-4 LE5 CMC 75". The length of the channel is 27 inches. Can you please share the right part number that I should be ordering. Thanks.

26 4 CALDWELL CM printed on side

the measurement in the picture is 27 inches, and there is also a label in the picture, hopefully that can help you to identify the part number.ThanksJunguo

This part was installed by a window repair guy but is not the correct weight. I have a 22 pound window and the total length of the metal part and the glass only on my window is 27 inches. I hope I have sent enough pictures if not please let me know.

My windows right channel balance broke and I would like to order a replacement. The part# 26 3 HW CMC 7

Replacing 27 inch channel balance marked 2640 bsi nl These are hook and tackle. Not sure what parts to order for top and bottom, I think they are winged.

I am replacing the channel balances of a non-tilt window. The metal part measures 27 in, 1/2 in width. I can identify it as a 385 channel balance. I cannot make sense of the stamp of my old channel balance. I need help. It reads 26-3 GE5 CMC 75, and I have an Alpine window. I am also attaching p ... (cont.)

27" which part number of yours do I need ? photo shows 26 3 bsi rp I also shot a picture of the lower part of the window .

4 pc. . . . . . 26 5 IW CMC 11

My window is narrow at 22" and 58" high with no tilt. I measured the length of just the metal channel at 27". You can see the metal clip in photo of the Shoe View 02. The markings are not clear to me so I included a picture of that also.

Wanting to make sure I purchase the correct part. 27" long metal piece. Attached are photos.

Hello, I need both sides, thank you.

Hello, I need to know which part to order to replace the one in the pictures. The metal part is 27" long and 9/16th" wide. It has the following stamped on it: 26 4 FX CMC. Thank you!

Hello, please advise what part I need to order to replace the one in the pictures. The piece is 28 inches long and is stamped with 26 4 FX CMC. Thank you

Need to known what part number to order? Non-Tilt Window Channel Balances.

Hello, I need to replace a window balance. The metal portion is 27 inches long, not including the plastic ends. The metal portion is 0.5" wide. The bottom plastic part is a little over an inch in depth. The stamp reads "26 5 BW CMC 7". It is for a Milgard, single hung, non-tilt window. ... (cont.)

This slider broke (string popped) from builder grade window. See pic of identifying # (?) Need 2, as other is askew in track, too.

Hi ~ I need twenty channel balances for my Kinro windows. (27in x 1/2in) Can you please advise what part to order? Thanks!

Length metal tip to metal tip 27 inches.