Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

Fiberglass mobile home window... installed in a Cavco mobile home. Metal end to metal end measures 27". identified as 26.4 B.S.I. RK

1/2 Channel Balance stamped with 26 4. Im assuming that is the length and width. Several of the ID pictures online look similiar. Its hard to tell which ones I have.Can you also provide the part number of the plastic pieces found attached to the window based on what channel balance I have? or do you ... (cont.)

It says 2620 bs1. It's 1/2 inch wide

Hello, I have a few window channel balances needing replacement, they are marked as “26 4 BX CMC 11” and when searching for that I see 26” versions, but the metal part of the balance measures at 27”, so I’m not sure which one I should be getting. It appears to possibly ... (cont.)

Hello - I am looking to recommendations to replace these on 2 windows in my house. The small window one is marked 26 4 DN Caldwell. The Metal part is 27 inches long. The larger window is marked 32 9 BN Caldwell. The Medal part is 33 inches long. I appreciate the advice.

Hello, I am in need of assistance to determine which window balance is needed. I tried to take photos of the balance at a similar angle to what is on your website.

the channel is half an inchit is 27 inches long not including fittings 26-4 fa2 cmc 13 is written on the unit

Looking for non tilting channel balance. The only number I can see on it is 2630 the metal channel is 27" long and looks to be 5/8" wide

27" long, 1/2" wide

Need one(1) of the pictured balancer

Hello, The rope for our window balance ended up breaking recently. I'm looking to find a replacement for this one. Our window weighs 20 lbs and is a non-tilt. The width of the balance is 1/2 inch with a length of 27 inches. Both the top and bottom fittings have wings that measure to 15/16 inch. The ... (cont.)

Channel Length = 27 inches. There is no stamp. These windows are in a Fleetwood triple-wide modular home. All of these are sliders that are the same size. At this point I'll need 6 balancers for three windows. I don't know if these are/were custom windows made for Fleetwood or not. Each window is a ... (cont.)

Hi, I am the wholesaler who called earlier about pricing on 36x 2640 balances. You suggested I send some photos of what we are replacing. Of the 36, 8 are marked 2640A. But they look identical to the 2640. The 2640A came off a narrower window. All are 27" channels. Thank you.

Metal channel is 1/2" wide and 27" long. Has markings on it that say 26 4 EW CMC 10

I need balancers for both sides of this Milgard Classic single hung. 26 4 AW CMC 7

Hi need replacements for these - can you assist?

I am looking for at least 4 items.

These Milgard windows are about 28 years old, house was built in 1996. They are vinyl windows. The steel channel is 33" long on one and 27" long onthe other. The steel channel part is about 9/16" deep and between 9/16"-5/8" wide. They are marked with ink as shown in the photos. Thanks! ... (cont.)

27 7/8" total length 5/8" thick no name on the window

I need to buy new balances for my windows