Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Hi, I need to replace the balances in my window. I believe it is Caldwell. It is 30 in long. The stamp says is 29-4. I'm not sure about the guides though. Can you help me identify the right part?

On my windows I have attached balance 29 6. Please find attached picture. Also it appears that my Sash CAM (caps) are also busted and need replacement. Can you please recommend right product to purchase?

They are 30" long 2 are 29-9 12 are 29-4 also need 14 18-115 top piece on windows they are cracked

John Spoke to a CSR a few minutes ago and was requested I send photos of what I need. Would like to order two balance rods, four top sash guide, and four take out clips. Let me know if need anything else.Below , there is an attached picture of the balance rod removed (laying on a blanket). The oth ... (cont.)

Need Channel Balances and Top Sash Guides.Weight of window is 24 pounds.Balance length 29 inches,1/2 inch channel, wings bottom and top, bottom fitting depth 1 inch. Stamp is "29 4 PR BST".

The balancer has following part number. 29 4 HW CMC 7 I need to purchase the replacement.

Need to replace. It has a broken cord and no end clip. 9/16" wide, channel portion length is 30". Marking = 2930 (sideways S8) NA Can you help me?

Hello i needed 2 of these please

Please help me identify this part (29 4 HV CMC 7) to your series. Thank you, Gary

Non tilt window, channel balance 30" length and 0.5" width. See attached photos for rio and shoe. Thank you

Could you please help identify this part.

I found 2930 nmBSI stamped. I measured 30" long without hardware

Good afternoon. I need a window channel balance. The number in the broken one is 2029. Could you please tell me the right part?

I am looking for a bit of help on identifying the correct parts I need for a window project. I have 4 different sized types of windows. Question 1 - I have included a few pictures and would like to confirm if the correct style for these balance springs should be model 15-004? Question 2 - I have ... (cont.)

Looking for a block and tackle window balance to replace mine that have stamps: 2315 and 2915. The windows are 24 yrs old and difficult/noisy to open and close. Another issue is that the window balance gets stuck at the top of the frame, even when the window is down/closed. LMK if there's another pa ... (cont.)

Need to order two window balances as in the picture. I believe they're 30 inch. They go on a PGT double Hong Window series 4000 if that helps.

Good evening, I am looking for a H-LC25/35-52 x96 channel balance. There are no markings on the channels. Please see attached photos. Thanks, Moe

One balancer is stamped 29 6 bsl c Length 30 inches The other balancer is stamped 29 4 bal c Length 30 inches

Need to order a replacement

has a label of 29 4 HW CMC 7. The metal frame is 30 inches long that does not include the plastic parts just the metal frame. It looks like the clip on my window is broken so I will need replacements for them also. Thank You for your timeJamie