Viewing all customer Discussions for:

39-028E Ellipse Style Single Arm Operator, 9-1/2"

Entire crank unit needs replacing. Two or tree turns before engaging and slips when trying to complete closure, so closing is not possible using only crank

Need correct size window operator - Wright - Casement Window

Hello, I am looking for three crank replacements for these casement windows The faulty cranks are from Norco and were installed in 2000. The image on the far right is one that has been recently replaced...but I do not know the manufacturer or part number.

The latch doesn't fully close. You can push it closed but it pops open again.The other window has to be pushed closed from the outside and since it's on the 2nd floor and separated from another window ( that opens) by a window that's fixed, so it's a bit dangerous trying to close it. We are movi ... (cont.)

The window currently won't close all the way. It will crank in with about a 1-2 in gap from the seal. When you turn the crank at that stopping point, nothing happens. The window opens just fine, but I would venture to say that we need a new one. Unsure what will be a best replacement. We just bought ... (cont.)

lock and crank handel and window rod if needed for new crank handle Need 2 sets what if any finishes available

I am looking to replace the cranks on a weathershield casement window. It has a left and a right side. The numbers I found on it were 3581R and 3581L.

It says R.O.W. on the side. It's very old but maybe you have a part that would work. It's for the left window if you are in the house looking at the window and the window opens to the left. Thank you!

I need the crank of the picture of the closed window the open window is the same size window but they have a Identifying marks on it that may help you find the part that I need

I took pictures of intact left window and the right window with bar missing. I need the 11 5/8 inch long bar

Is it possible to only replace bottom hinge? The window does not crank back in to close. Part #30744 Truth

What is the closest match to this crank. I'm not finding an exact match.

the casement is frozen up I want to replace it but cannot find one Given this website by the guy at the Ashland Home Depot I am working on getting it removed I am not much of a handy man

I am trying to find a replacement for this operator. The handle say Malta, but there are no real markings on it other than that. It is 9.5" from the pivot to the end. The nylon bushing that slides in the track is 9/16". The spacing between the two farthest mounting holes is 3". The flat part that is ... (cont.)

Marked on the bottom LH 45135 The arm is marked 40051B

Hi, Attached are 2 photos of a crank I'd like to replace. The arm has an offset bend. Can you tell me if you'd have a replacement part and also how I should measure this? Thank you

Hi, can you please let me know what replacement part number I need for this window opener. Thanks

I have a old Truth window crank from inside the home hinged right lock left sides

I need some hardware to replace in casement windows. Long leg is about 8" . Short leg about 5".Six windows total. 3 left and 3 right. Crank handle has a bird on the end. I appreciate any help you can give me.ThanksStephen

I'm looking for a window crank assembly 40055 LH Please advise on part number and order process