Viewing all customer Discussions for:

S395-29 29" Series 395 Channel Balance

This is for a sliding up and Dow window non tilt. Not sure if the stamp number readable.. 28-4 LX CMC 7

I need some help identifying this please

Measures 29 inches long and 1/2 inch wide

Code on my old channel is: 28 3 AV CMC 7 When I measure I have: width 1/2" Length (metal only) 29" Your series match is 395

Hello. I need some channel replacement parts for Atrium windows non tilting. Please see attached photos and advise as to which parts to order for correct fitting. I thank you in advance. Tyler

Hello, Needing to purchase 4 replacement balances. They are 29" long. I think I need the S380 with the 2830 stamp, but the bottom boot on mine don't have the outside retaining clips. Wanted to confirm they were the correct ones before purchasing. Thank you very much!! Michael

I know it is 29 inches - metal end to metal end. Going to need 4 and also some window clips. Please let me know which part and how much this will cost.

28" long metal part. 9/16" wide. Atrium window non tilt about 18 years old.

Thank you for help in identifying and supplying, hopefully. Howard.

Dear Swisco, I need to replace window channel balances labeled "2820". I have attached 3 photos to help identify the parts I need. Thanks. Cary

Wow...wish all businesses I deal with were as pleasant and knowledgeable as Jasmine!

I have approximately 12-13 year old Atrium Windows. Some of the balancers have gone bad. A few years ago I was able to get replacement balancers for some of the Windows. Recently I realized that one of the Windows takes a different size balancer. A renter removed the balancers from this window and d ... (cont.)

Atrium window channel balance 28 3 HU CMC 2 Actual length of metal frame is 29" Also need the clip which goes in the slots shown in pic 0149 to keep the channel balance in place when removing the sash.

What would be the correct item to order to replace these?

The designation on my existing balance is: 28 3 GV CMC 2. Can you please verify which balance I need to purchase? Thanks, Virgil Smith

Hello my window channel balance has failed and needs to be replaced, please help review my photos to see if you can point me in to the right replacement. Current window is aluminum and weights ~ 23lbs Channel balance is 29" long and has top with wings and bottom without wings. From the measurement ... (cont.)

Broken part , cable broken need new ones for each side. The metal part measures 29" also need 4 clips. Atrium door & window company of Arizona is the window manufacturer

I'm looking for channel replacements for old Viking hung windows. One window shows 2810 while the other window which looks to be the same size has 2630. Other markings include 26 3 BS COLDWELL.

I needs four balances to fix my windows.

I am in need of four 30 inch window channel balances. Can you tell me what parts I need based on the photo and description? Thank you