Viewing all customer Discussions for:

S395-30 30" Series 395 Channel Balance

Have 29 5 jw cmc 11 springs in a pgt 30" tall single hung. Looking to replace.

I have 30" channel balances of which I will add a picture. It is 30", but how do I determine the series? S380 or S385 or S395 Also it has a stamp on it 29 3 GV CMC 7 Can you please advise which is the correct replacement?

need 4, two each

Take a look at our Series 395 balance, 30 inches long, with the 2920 stamp option

I need to replace the sash balance on three of my sliding windows. The part number imprinted on the side of the balance shows 29 3 BQ Caldwell. I've attached pictures from one that isn't broken. Could you verify if the replacement part I need is Swisco S395-30? I also want to commend your company o ... (cont.)

Hi - I'm looking to replace some old channel balances for a window in my home. I need help selecting the correct parts. It is a non-tilting window; the metal channel is 30" long, 9/16" wide, 5/8" deep. They are marked "29 3 IP Caldwell" I know that the plastic bits at the end vary - I've attached ... (cont.)

The guide is 1/2 wide, the length is 30 inches. The markings are hard to make out, but they appear as I posted. Also need the top plastic stop blocks on window that match the slides. The window is fairly large and heavy measuring 48 x 30. Sorry no scale in house to weigh it. I have more pictures if ... (cont.)

This is in a PGT aluminuw window, It says 29 4 HP Caldwell on it. I have no idea how they're installed but I would need both left and right....I'm thinking?

Metal bar is 30" , spring is17"

Part number 29 6 Ex Cmc 2

1/2 channel width.Top appears to be a 19-005 and the shoe looks like a 15-002. The measurements line up with these parts. The metal channel not including top or shoe is 30" long.Thank you,Dave

Metal part measures 30 inches pictures of plastic on end. I willl need 4 complete units

Good morning, trying to identify a 30" (metal only) window balance. Marking says 29 4 DQ CALDWELL. Window measures 50"w x 60" h. Please let me know if this can be identified or if any additional info is required. It is not a hurricane impact window.

The metal channel is 30 1/16 long. I will need a total of 4 springs

Please let me know if these photos are sufficient. There is no stamp on these balances - only numbers that are barely visible. It seems to measure 30 inches but the numbers that have worn off start with 29. Thank you,S.

The rope on my window balance broke and so the window only hangs on one balance that has the rope intact. I took pictures of the balance and a picture of the sticker I found on the inside of the window. Could you help me figure out what I can replace this with? These are Atrium windows and the metal ... (cont.)

I lifted the 62 by 52 PGT single pane sash window and the long metal bit from the right hand side popped out and stayed at the top of the window frame, I think it broke through the top, with difficulty push it back down with the mettabit inside the bottom window and I was able to close and lock. I'v ... (cont.)

I need to order these rails in the near future---installed in East Coast Florida block home in 1997--window size if aprox 53 x 33---Thanks

29 3 JQ CALDWELL stamped on side.

Hello, I need to replace a no. of channel balances in my home. My home was built in 1997. I have removed the old balances from one window and would like to know if I can get replacements from you. These balances are marked '29 2 LP Caldwell'. There are other windows of different sizes that most l ... (cont.)