Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

This is a right hand TRUTH window crank, it has the number 30710 stamped in the center of the crank. I have included pictures of the crank. Thank You.

EntryGrand Truth. No numbers found. See pictures attached. see new parts but want to make sure that right parts are ordered. the shaft worn and came out of and didn't engage with the gear wheel anymore.

Hello i need this part

Hi there - I need to replace a broken crank on my Milard window, but have no idea what the part number is in order to purchase the corrrct one. The windows are from the mid 90's if that is helpful. Any advice or direction would be much appreciated.

Please see attached. Thank you, please see attached photosof each of 2 operators. The measurements of the pieces for each operating unit are as follows (inches): 5.75 11.5 8.0 And 4.5 11.5 9.0 Thank you.

The window opens fully but it won't close. I was under the impression that the Sprocketts ( not correct name ?) but the (Screws) were worn out and so the crank can't engage with the ( whatever it is called.

#9669

I'm looking for a replacement arm for a casement window. The current arm is labeled Entry Guard Truth and, once extended, pops off the bottom of the window, so does not work to close the window. Can you identify which replacement hardware I need?

I need 5 of these cranks 30744A,40754B,30744B, 30818B, 40754A I wrote these down that were on the cranks, but was told these were just the inventory number of the parts. The letter behind each of these numbers, was located on the short arm of the crank

Hello, need to replace three window cranks, but I have eight windows and I will purchase five additional cranks. The name brand is Lincoln. Each hardware has two cranks and one maybe two brackets that extend to open the window. The top bracket has two numbers: 1. L30841 2. 20810 The second bracket ... (cont.)

Hi, I'd like to make sure I'm purchasing the correct parts. I think I found them on your site. Stamp on old parts says Entryguard 31538. Would this be the correct parts page for my window? Your part number 39-031? https://www.swisco.com/srch#/?resultsPerPage=24Thank You for your help, Chris ... (cont.)

L30841 is on the arm. If you are looking outside in it's the left window that cranks out

Over 20 Years old and wanting to fix broken parts.

Windows likely installed in 2000. Need to replace opening mechanism on several, but having a hard time determining manufacturer, part number, etc.

The main shaft that run the opener gear detaches and screws out of the housing

Replace the other side

the window will roll out, but not back in. I cannot separate the gear auger from the handle. I wonder how that is done as the handle is usually sold separately. It appears if I could get the gear auger separated that there is a little silver seal that maybe could be pounded in place and then the han ... (cont.)

Please advise which operator need to order for replacement. I need both left and right Thank you

Want to change, window open but doesn't close

Hello, I am looking for 3. They are on the right from the inside: the long arm could be 9.5". The shorter arm should be close to 4 3/8". Brown. Right fromthe inside of the home. There is a number on the operator 20810A. Thank you!Please send info to