Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

Need parts for left and right windows. Turn handle is stripped out and can't open or close.

As you can tell from the photos the end of the auger part of the window has broken. I don't have the part numbers but they are Truth hardware pieces. Do you have the piece that i can screw into the handles? Or if they are part of the handles that would work as well. Please let me know if you need ot ... (cont.)

Hi I believe the entire operator needs replacing but wanted to get an expert's opinion. The crank has 45012 printed on it. Please help identify the parts that need replacing. Thank you.

We need the window operating mechanism and handles for Crestline windows installed in approx 1990. Please indicate if you need further information to identify the parts. Thank you. Roxie Hansen

I have found this one on your site for the smaller windows (Truth Hardware Entrygard Dyad Window Operator 39-035) but need the dual arm assembly

Hi I have a broken part on my window. I can open but cannot close the window I do not need all parts for L31538A. Just the part you can see in the second picture but do not have the code. Thanks for your help.

not sure what brand or model

Hello, Looking to replace some cranks and I need a little guidance. They are Truth cranks. I measured 8-3/4 for the arm, but I probably didn't measure correctly. I will have to go back and do it again. I did take some pictures of the model numbers, but not sure how much they will help. Any guidanc ... (cont.)

I have Vetter casement windows from 1998. The corner on 2 of the windows doesn't pull in and close properly. Is that a hardware problem? Are the parts available. Several numbers on the hardware: 20810, 515381A. Thanks

I am looking like this: i will need right and left. I hope you can help identify my request.Also i will need cover and handle to this mechanism brown colour, thanks

I have five wooden casement windows where the worm gear is stripped so that the handle just spins. It sounds like the only option is to replace them. I have included pictures. The general brand is K K but the only number I could see is- 20810 4 of the windows are the same size, one is smaller. I ... (cont.)

30710 40245

Bottom sill appears to be one solid strip not, sure how to remove. Could someone assist me? Any help is greatly appreciated.

I have this truth operator that I need to replace. Your dual entry brand is close but the screw holes don't match up. Will your work for my needs?

Hello, Seeking a replacement crank (Truth brand) for a Pozzi window. Please see attached photos. Happy to answer any questions or provide info. Looking forward to your reply, Karen

I am getting ready to sell my home and I have several window cranks that need replaced. Both left and right. They are around 31 years old. They have "K/K" on them. See picture. Can you help? Thanks Ed

Do you have this crank assembly in stock. Thanks, Mitch

Hello, my window will not close because the internal hardware has been stripped and can not grip itself to crank it close.

The gears seem to be in tact in my Pozzi window. The screw gear part seems to be stripped. It will open. But not close. The rotating arms seem ok. Do you have anything to help me?

My window crank is no longer working and I think I need to replace it. The cut out for the crank is 5in. The long arm that says entry gard truth is about 9in. The part that says 20810 is about 4.5in. The part attached to that says L30841.The part attached to the bottom of the window that swings ... (cont.)