Viewing all customer Discussions for:

Door & Window

Hi, one of the teeth in the gear is missing so the crank slips when opening and closing. Is there a replacement crank I can order? Not sure what would be a match. I've been procrastinating fixing this for about three years and my daughter keeps asking me to fix it - it's her room's window ? Thank yo ... (cont.)

Dear Swisco,I am looking to replace the balances on my windows. I believe these are the block and talked type, but I am not sure. If they are please advise on the replacement with your new recommended balancers.Regards,Dan

Hi there, we have several windows on our sun porch that need replacement parts. The crank just spins, and nothing happens. Each bank of windows comprises four windows that all open when the lever thing is cranked. The window bank is about 44" wide by 65" high. Do you sell the parts needed to make th ... (cont.)

Looking for 1" wide pivot shoes for old spiral balance tilt in windows. No manufacturer on any of the windows. Please help

Do you sell this same handle but with 1 3/8" mounting holes?

I need a new handle, my door is drilled for 4 15/16 center, do I have to drill new holes?

Looking for replacement seals for my Caradco double hung windows. It's hard to find anything close to that bottom rail seal. Please help! Thanks David

I don't have any photos but only have opening cut into sash. 1/4 inch wide by 1 inch high.

Good morning, I purchased the wrong item last time in May these are for 20-year-old windows. Allside should be brand name. The ones I returned were 26-119 not sure if I should have purchased 26-234 instead not sure can you help? Thanks Rick

Looking for this part (see photos). It is a latch to a sliding glass door.

Looking for a window channel balance for a certainteed 4050single hung white vinyl window33" long, 1/2" wide channel is the inside dimension vent weight is 28 poundsthe part# stamped on the channel is 31 5 FV CMC 2Originally this was an "Insulate" Brand window installed in 2003I need 4 of them ... (cont.)

Hello, I am trying to find replacement slide bolts for my old storm door window. They have a raised part at the back of them to hold them in. I tried to get photos as best I could with the window flipped upside-down. The measurements as best as I could get are: 11/32 thick 13/32 high 1/2 nose long ... (cont.)

Two of my windows need replacement channel balances. The windows are dual glazed, aluminum, single hung, about 30 years old.Window 1: Channel is 1/2 inch wide x 34" long. Window is about 15 lbs. The channel has the following imprint: 3320A B.S.I. (A is upside down - see photo).Window 2: Channel is 1 ... (cont.)

My parents 1980 condo has the original handle but the replaced the lock/striker in the door frame for a doggy door unit. Now I'm needing to put door lock back, HELP! Need complete locking kit.

Looking for a replacement handle for my aluminum double pane sliding patio door. Installed in late 80's. I'm certain it was purchased at a local big box store, Lowes or Home Depot.

channel balance for non-tilt sliding windows. 26 inch.

Need to replace my sliding patio door Handle is patent D-466787 The insert part is patent 6 264252 and 5 820170

In need of window replacement parts taken from aluminum windows inside a 1985 built home, because it's hard to push left or right for opening or closing of windows. We had no information related to the brand nor the part number for the replacement parts except the photo image of the actual part unsc ... (cont.)

Can you help us identify if any of your parts would be able to replace this quick tilt window part. Thank you

46' x 52" window. markings 22' 4' IQ Caldwell. 1/2 "- 23" length