Viewing all customer Discussions for:

Door & Window

Just checking to see if you can identify this part and if so, if you have it in stock? The only identifying mark says 1190 5. As shown in the photo. And it measures 1/2 inch width by 12 inches length from metal end to metal end. And total overall length with plastic ends is 13 inches. ... (cont.)

This lock has goes to a 2024 PGT vinyl hurricane impact window. 2 7/8 inch long and 1 inch wide.

Looking for the attached pictured rollers Thank you

Sep 08 sash controls Sioux falls SD

I really need your help to order the correct parts. Directions for installation would greatly be helpful. The windows are non tilt The balances are 36” long. The balances are 5/8” I need replacement parts for 15 windows to start. I would really appreciate directions about how to install ... (cont.)

I think the # is either 2857233 or 2557233. It's hard to read and it's flat on one side. I ordered and recieved tie #32-149 but it isn't flat on one side. It was order #3140903 dated June 22, 2025

Plastic part with imprint M 513

My thumb latch and door handle need replaced. See photos.

I need the two rollers for my Reliabilt Vinyl Sliding Patio Door. The size is 72 x 80. I also need the track. The track is aluminum 1 5/8 width and the track is on the middle of the aluminum plate.

I bought the Truth EntryGard, but it doesn't fit. The new link arm is longer than my original. Do you have one with a shorter link arm, by about half an inch?

Need that part

I am looking for this roller for sliding door. I have attached pictures below. Please let me know if you need any further information. Thanks Lisa

Look for the bottom track assembly for a left opening and also right opening

I'm not sure

Hi - which pins would work here?

Looking for replacement for certainteed 2009 window glaze.

Need new for both bottom rollers

I want to replace a broken door handle on my sliding door. I have photos to explain my existing door handle. I believe the mechanism is what you call "surface mounted." Mounting screws are 2 and 3/4 inches apart.

Think it is a casement sill mount split arm operator, need a replacement. It doesn't close and need to push it from outside while someone cranks the arm. Can find only 2 stamp #s on it, attached are pics. Please let me know what else you might need.I found an old invoice for replacment screens and ... (cont.)

I need to purchase replacement vent stops and the slots that the vent stops fit into. I found the vent stop but can not find the slot. The vent stop product number is Product Code: 26-474Ve