Viewing all customer Discussions for:

Door & Window

Please let me know if you have this handle. It is cracked and I need to replace it. 10" long and 1" wide

I need one of these to fix a customers window. Truth Hardware 30472 R.H.Please let me knowTom

Need to purchase 4 balance springs.The tip is yellow.Not certain what length to order. Would assum 31".Please supply part number to order.Is the slide/lock block available? Will purchase several of them, just Incase needed.ThanksRay

The way the lock on my sliding glass door works is I push up a button that moves up a latch that should then secure to an attachment that locks it in. See attached pictures. I'm looking for a replacement part that is the black part attached to the side wall where the sliding glass door slides in t ... (cont.)

Hi, I have two different windows that need sash replacements, both from the same manufacturer. I've determined both to be Series 385 replacements, but I'm trying to determine what length I need. When measuring ONLY the metal in length (I am not including the base or shoe in length, only metal par ... (cont.)

Need complete inside and outside of door handle. It is a Cole Sewell door #11259796045 38 I cannot figure out how to add photo

21 12 Ok BSI Sash weight 36 pounds American Crafstman

Need 2 replacement balances for white vinyl repkacement window

The number on the balance we need is 3040.

To whom it may concern : The 22-year-old windows in my condominium need some parts. I hope you have them. I need the side latches that allow the windows to be tilted inside for cleaning, and also hold the windows in place. The latches are 2 5/8 inches in length on the top, though they might look l ... (cont.)

I need to replace 2 pieces of glass and the snap in widow glazing is in bad shape. the long side is about 14/16 of an inch wide and the narrow side is about 6/16 of an inch wide. What is there now is aluminum but gray vinyl will also work

Need this roller parts 2 of themThis part has markingsPE/DELMAR ENGMade in USA

Hi,I sent you a post earlier for another part however, I forgot that I also needed a window sash lock. I'd like to make sure I'm ordering the correct part number based off your data base. As you can see, the back of our lock has a part number; 11R-7. Thanks again.

Hello, I've got a window vent in glass blocks that needs a part. The window has. Two arm that pivot the window open, and the screws in one of the arms rusted and snapped off. While trying to replace the screw, the other end broke offa d the rivet is stuck in the metal piece. I've included a pic of t ... (cont.)

Need to know what to order. I was thinking there 30in series 385

Hi, I need your help ordering the correct parts and sizes for our tilt windows. As you can see from the pictures, our windows(all of them) have plastic covers(?) over the spiral balances and are broken in several places because of the sun exposure)and not metal. I'm not sure what sizes to order. T ... (cont.)

we need a window crank that opens opposite of this photo. It needs to open to the left. We have ordered a 9"left ark and evidently it is not the right part. can we get one of these

I have previously order replacement window balance hardware S850-34 with black 1 1/4 width shoe. I think the S850-34 is discontinued. Can you give me the list of replacement hardware that is now available.

white nylon tip, 3/8" dia, 29" long

2510 is on the balance. The other parts i dont know if it is the correct one.Please help identify