Viewing all customer Discussions for:

Door & Window

I need another screen door latch and screws like in the attached photo. The screw holes are 4" apart.

Lettering on arm says Anderson Windowallsreverse has stock no. 7198-17Picture Window crank 1 shows sharp edge where it may have been broken off

I'm trying to find a replacement handle for a sliding glass door only #s I have patent #s lock 3596954 inside lock, 919218 plastic handle support (inside handle) wooden handle 9 3/4 inches, inside lock housing 7 3/16, screw holes 4 15/16 door itself three holes large one in center, handle set sandwi ... (cont.)

Looking for both sides for 6 windows

Which model do I need? Thanks

All of the windows in my house came with a white plastic grille clip the same dimensions as your 55-184 except the plastic pin is 1/8" in diameter as opposed to the 55-184 that is 3/16" in diameter. Do you make a clip equal to my needs? I realize I can drill out the opening on my windows to 3/16 ... (cont.)

Good morning I want to buy a window channel balance to replace a broken one, but can't figure out which one. I have uploaded several pictures The metal channel measures .5" x .62" x 28", without plastic parts, and is stamped 2730 GM on one end

Can't found on your website

Simonton window balance

I need a new tilt latch and channel balance. I'll send a new picture of the tilt latch and was told by a representative that i'll need to weigh the bottom sash since there's no stamp on my balance.

Cole Sewell Door Reg# 09259796042 31. Need inside mechanismNeed replacement inside mechanism or at least the receiver for the square pin

Hi - I need to replace several window's worth of balancer. The original looks like your 21" Series 380 with 2040 strength. However, the bottom shoe is different in that the lowest pulley is in the plastic shoe instead of the channel. The attached photos show the part I'm trying to replace: C ... (cont.)

Greetings, Need new window slide balances for Jordan brand non-tilt. Metal section w/out plastic ends measures 23". Thinking it's the 351 series but not sure how to determine the weight option code. Thanks! Roger

Hello,From the attached photos, can you let me know if your stock window glazing will be suitable to replace my damaged glazing?My damaged glazing has a surface size of 7/8" with a snap in size of 5/16".Many thanks,Paul

The number stamped on the channel balance is (h 2428 #). I need replacement channel balances for 3 windows, a total of 6 balances for this size. The window size is approximately 47" x 26". The channel balance I have looks similar to the 25" Series 395 but I'm not sure.Photos not available. ... (cont.)

My balance shoe is a little thicker than yours. Any chance this has to be custom made?

There are no apparent markings on this latch. These latches appear to be original to the house, which was built in 1980.

Hi I need two pivot bars for one of my windows but, I am having a hard time matching it with one of yours in the inventory you show. Please take a look at the uploaded file where you will see a sketch with dimensions. all dimensions are in inches. thank you

I need a replacement operator that will last. The ones that I am buying from home Depot don't fit right and they don't last. The picture of the brown operator is an original one that is more than 10 years old and still works great. I need a replacement like that one. Also, I need oversized screws. ... (cont.)

I need a lock cylinder for Legance 3 patio door DDSG Tri-K-36. I have a question about the one your company sells. I purchased a lock cylinder locally but the key can only be removed in one position. I need the key the be removed in 2 positions ( locked and unlocked ). Will your lock cylinder 82- ... (cont.)