Viewing all customer Discussions for:

Door & Window

I have tilt out windows and purchased what I thought were the correct 1/2

Looking for a replacement for the 23 inch length - 1/2 inch width channel balance for non-tilt window. I also need TOP SASH GUIDE need 10 pieces of each. Length:23 inches Width: 1/2 inch Markings: 2206 Thanks

I need 8 of these operators. Can you identify? 4505601

Yes, I am needing help finding a replacement handle for my rear sliding glass door in my house. It appears that the hardware internally is fine, but I need the outside handle and possibly the inside handle replaced as well. The outside handle pulled away from the screw housing from over the years wi ... (cont.)

I would appreciate help with identifying replacement part for my window I previously ordered some from you and they did not work for me. Looking for a better recommendation so that I will not have to make another return.

I am looking for widow latch part # 5,139,291 - 9A

Trying to replace these and not sure what to buy!

Hi Please see the pictures of my sliding glass patio door. The keeper is missing and I need a replacement. The door is a Simonton windows SGD R35 72x80 series 06-05 patio door pl # 063-039. Thanks

I have milestone windows and over time the sun has dried out the plastic casing and they have cracked I'd like to purchase replacements

I have a problem with one of the sliding windows in my son's condo unit and I want to figure out how to fix it. The window is shut as far as it can go, but it is not latched in the middle. It is missing the strike plate by about 1/8". Is this a problem with the frame or installation and can it be ... (cont.)

I purchased new door handle from you for my door this month (Dec.2017) and have it. I see door needs a new track and rollers also. I need part # for track and for rollers. Security is urgent and as for rollers,I can't take the door off and to find the rollers before they are shipped while leaving o ... (cont.)

Just watched the video for the 40-058 abd I think it would work. I don't know what size bar I need though

Hello, My name is Chuck G and I ordered this part # 39-008 last February. The operator had a crank on the right hand side which was fine for that window. Now I need the same operator but with the crank on the left hand side. I don't know how to order this on your website and have already s ... (cont.)

I need to replace a folding casement window crank handle manufactured by Truth, Part No. 5560082. The plastic section that fits over spline shaft is cracked. The shaft has 12 splines, but I can not determine if the shaft diameter is 5/16" or 11/32". Pictures of the crank handle and spline shaf ... (cont.)

No name hardware. This is vintage late 70's early 80's (this is what I am told). Looking for the tabs. Also looking for the handles. They are left and right handles because the handle has a sweep.

Hi I want to know if you guys make a replacement lock with the key entry for this lock thank you.

Hi i was wondering if you know what crank would be best to fit this part Caradco

Please help, these windows are 18 years old and in the picture the yellow piece keeps getting stuck. The other side of the window is fine. Do you carry this piece? Thank You Frank G

I need a few operators, can you ID ??? Thanks! David S

I need to order two (2) mortised hook latches to fit the attached keeper. Can you determine if I need the 82-239 of the 82-265 based on this keeper (and thumb turn) Thanks, Fred