Viewing all customer Discussions for:

Drawer & Cabinet

We already ordered Grass Under-mount Slide Locking Device Kit from you, but now we have discovered that we need the mounting bracket part that goes connects to the drawer itself. Then we will attach the Slide Locking Device into that bracket.

I am trying to find a 3/4" wheel that I can attach to left side of these pictures where the wheel is missing (original was put on with a rivet but I need a screw based one now). Alternatively I could purchase a new set of rails if you have 20" with the L-shape at the end (I have not been able to ... (cont.)

Looks like a number of people were interested in replacing #452 guide with a similar part from your portfolio. Any good matches?

I have a bunch of kitchen cabinet drawers that have two pegs that fit into the cabinet fascia piece. Needless to say, these detach all the time so I end up with the cabinet face in my hand. I am looking for some corner braces that will hold the sides and bottom piece of the cabinet to the fascia ... (cont.)

It has "R1" stamped on it. The dowels/pins fit into holes in the back of the cabinet.

Pennsylvania House drawer chest and armoire - purchased around 2007. Opening at base is 1 1/4". The top part of the glide is 2 1/2". Opening where wood on drawer slides is almost 1 1/4". Please let me know if you have all the info you need and if it is clear. Any help would be appreciated. Thanks. ... (cont.)

I need a drawer roller track replacement,this picture shows the original,thanks,is 21"and 3/4 long 3/4

I need a pair of rear drawer track sockets. However, I need your guidance. The ones that I must replace look exactly like your product code: 32-012. My broken sockets seem to be a little larger than this pair. Remember, I am measuring broken parts, but my approximate measurements are: 21/16" x 9/16" ... (cont.)

Bedroom set was purchased in 2002. 'Universal' is the make. The drawers insert with a center middle track and a plastic glider on each side of the area where the drawer inserts. It is a little over 1.25 inches long and screws in to the dresser. It is l-shaped but has a triangle type piece on the ... (cont.)

Trying to help a friend locate hinges for some Brammer cabinets from the 70's. They are face frame mounted non self closing and the base of the hinge that mounts to the door and the exposed face mount are flush when the hinge is in open position.Can anyone be of any help?

Can you also use these for cabinet drawers?

Looking for Grant drawer slides for a desk drawer. The slides measure 22". We are trying to obtain one complete set (for one drawer ). Any assistance would be appreciated

I see the length and width dimensions for this item on the Swisco Web site. What is the height?

Look at pictures I sent you will see the White plastic Glide mentioned above. I also need the stud and rollers that fit this drawer aluminum side rails pictured. They are free spinning plastic wheels on a stud that presses into a hole on both sides of the drawer. Drawer then hangs on the plastic # ... (cont.)

the back post measures 1.5 inches high and 2 inches wide with a depth of about 3/4 inch. which part should I use. You have one that looks very similar, but it appears as though mine might have been istalled upside down. Thanks.

REISS MFG CORP N.Y.C. R-26 PAT. NO. 2667233 SIZES- Guide WIDTH 3/4inch x 5/16 inch depth - Overall width 2 inch

Is this a part that you manufacture or have in the past? If so, is it still available and how do I remove the old one? There are no visible screw heads. Thanks, Laura

I am looking for a replacement left side. the one in the picture is the right side

I need a couple of these for replacement... can you identify the part from the photo submitted... Thanks

Does product number 32-038 come in a right hand roller