Viewing all customer Discussions for:

Other

Hello, we need surface mounts for our windows and after looking through your catalog we realize you don't have the exact match for the ones we have. The closest ones are 26-078/9, 26-163, and 26-188. Will any of these work for our windows?

When we slide the door to open the sliding glass door lifts up on one side by 3/4 to 1 " and does not slide. It is very hard. Try to adjust the roller but not working properly. Not much effect of adjustment. Need help go dove. Attached is a model number sticker.

The windows are from the 1980's in Florida. The crank has no markings or indications as to the manufacturer. I can not detach the crank arm from the window as they appear to be bolted on.

I sent an email requesting a new channel balance then found how to send photos.Please get back with me so I can order the correct part. Belinda

I'm not sure who made them house is in Hemet California built 1995 the track measures 3 3/8 inch wide and is about 1 3/4 between the rails the doors slide on track is 45 1/2 inch long. There is no marking on the track and the glass doors are made by a company in Santa Clarita California, all I need ... (cont.)

I am in need of 2 new sashes for my window. I have attached pics of the Sash that failed and was removed from my window. Can you please help in locating the sash and also the pieces that go on the window itself. I added a pic of that as well

Hi,I'm looking to replace my channel balance and I have is, 1/2" x 29" long with stamp option of 28 3 AS CADWELL and 1 3/32" bottom shoe. Also i need to replace the 5/8" top sash guide as you can see from the attached photos my OEM have the top part measured of 1 1/8" wide with a small wing from t ... (cont.)

hello, I have a sliding patio door already installed and would very much like to change the handle to one with a key lock so someone can enter from the back.

The balance is 24" long by 1/2" wide by 5/8" deep. The markings show #2390-26. The window was installed on or about 2006. The PGT part # seems to be 65HSTRK. The window is installed in a concrete block home. I should note that there are no businesses within this area that perform repair of wind ... (cont.)

Need new parts inside and outside

Trying to locate correct part to order need the pair along with clip for frame. The metal cannel is 30 in. Windows are from nuair

Need help identifying these and need them complete with all the plastic ends so I can just swap them out length of metal is 30" not including the plastic.ThanksDave

I am needing to replace some casement windows cranks and the escutcheon and latches. The hardware I have is for Lincoln casement windows and the parts I have are in black. Please let me if you have something to match.

Window balance and also the plastic capst and balance upper clips

Good afternoon, I need some help identifying this sash cam. Any help you could give is really appreciated

Aloha,Please see attached photos of what I'd like to replace please. I need two of these.Mahalo,Joe

Can you assist me in identifying this part?

25.5" length metal channel. Stamp printed on it is: B.S.I. (PG) as well as the numerals 25 and 4. A photo that includes the stamp was added. Window appears to be Milgard and home was built in 2004 which is when windows were most likely installed. We need 8 balancers.

stamp is 2040 length 21" width 1/2" winged fitting I'm not sure about the measurement for the bottom fitting

The door looks appear to be locked into place I took it apart and it's even worse. All I know is my door is a silver line door #800234 I'm trying to get the lock to work again and I'm not sure what parts I need to replace it.