Viewing all customer Discussions for:

15-043 Terminal clip

I cannot find this part

lease see attached pictures of parts, attachment ends, etc. The housing of the balance is 29” long and is white in color. The spring inside is 16” long. Please let me know if you need anything else. Thank you.

Hello, I am looking for replacement Balancers for Double Hung Vinyl windows. The part is stamped 25TG and it is a little ober 26 inches long. I found the part on your web site, but the connection is different, as you can see in the picture it is a small square. Can you direct me to the correct pa ... (cont.)

I have a broken plain channel balance where the end fitting has come off. I don't see a simialr match on your site. The closest seems to be your S770 (22") but that is shown with the 15-043 terminal clip. My wondows have a small cast fitting that goes into the pivot lock shoe. The fitting looks simi ... (cont.)

I need Part

I have a several windows will these balancers. There are a spring block and tackle type balancer with the a spring steel clip at the top. The outter pain is a 17” and the inner pain is a 19”Also need to identify the tilt blocks there are 1/2” thick 15/16” wide and 1 7/8&rdquo ... (cont.)

Hola busco estas medidas de un contrapeso si me pudiera ayudar

I believe this is an International window. The stamped number on the balance is C 2040. The Balance is 21 inches long and the window weighs 20 lbs. The pivot shoe I believe is the 15-015 on your website. I believe I need a S770, 21 inch, option 21D. Please advise. ThanksMike

can you guys get these ???

Looking for balancer 9/16 width 22" 2120 See photo showing bottom of balancer no shoe on top. Customer is drilling hole at top to secure balance. Picture also shows the original balancer which was 20" with a tab to mount with no shoe on other end.

Please help identifying the replacement for this window balance. Please explain how to hook the replacement back up. See attached pictures.

Looking to replace four (2 paiirs) Stanek window balancers. C-channel is 30in long, 9/16in wide, 9/16in deep. The rivet holding the spring toward the top is centered 2-3/16in from the top edge. There are no plastic mountings on either end. Channel is only held in window by screw at top. The channel ... (cont.)

We recently purchased an older townhouse with a lot of these aluminum single hung tilt windows (30+).They're all in poor shape and need the counterbalanced replaced as well as the locks which hold the windows into place (they have some cheap plastic ones which break and we had a window fall out). I ... (cont.)

Data: 26 E BSI (this info on the channel) length 26" Designed for weight 22-25 lb Width 9/16" Depth 5/8" Lower Sash

window spring and rope broke and window wont stay up and for part number is U B 29G

28 in

I need 6 channels with the springs, the springs are broken. Some of the plastic connections are broken. I also can use the plastic molding that goes around the window in the inside.

Replacement channel balances for Hurd double hung tilt windows pre 2005. Might you be able to assist me with these parts?

Have stuck and broken balances need 10 to 12 of them already purchased shoes and bars from you they worked great Thanks- David

Hello, please, We're refurbishing these windows. We'll need all the railing parts and springs, etc.