Viewing all customer Discussions for:

39-156 Caradco Window Crank, 9-1/2"

How do I measure the size and brand of operator so I can order new ones? They say "EntryGuard" by Truth.

I need a replacement operator for a Semco casement window. The brand name "Truth" appears twice on the mechanism, along with a capital "L" and the number 31538. I hope you can identify the needed replacement part from this information.

we need to replace the whole gear mechanism. Thank you

I'm looking for new casement operators. I am not sure of the window manufacturer

Hello I believe that this is the entry guard operator, but not entirely sure, the arm is roughly 9" however I measured to the sill so the 10 3/4" to the center could be correct. please let me know,

Hi there. I'd like to make sure I'm ordering the right part. I need a casement window operator replacement for the one in the attached images. Is that something you can help with? Thanks, Marco

entry guard truth hardware, some numbers show in the photos, the assembly is broken and the windows don't crank out. I believe they are either 39-155/156 or 39-333/334 but I cant tell which, I need 4 lefts and 2 rights. Thanks

I need to replace the geared part of my window operator. It has "truth" stamped on it. The brass portion that holds crank handle has deteriorated and no longer keeps the handle in place. I have included two pictures. Thanks, Milton

Good morning. I need help identifying parts and manufacturer?David

won't open or close BiltBest casement window. Contractor will install if I get the equipment. Bob

Hi, I am looking to replace the hardware on all the windows of our home. HTL is the only identifing info on the hardware I've been able to find. Windows were installed in 70's I believe. Please let us know if you have any products that can be used to replace these units.

I don't know if I have the right terms, but I am looking to replace the crank mechanism and everything except the hinge on a casement window. If they are available in a less corrosive metal like stainless steel, that would be optimal. Thank you.

We just purchased a home that was built in 2004 and some of the windows are difficult to open and close. We thought that we might try replacing the hardware in one of them to see if that is the problem. I did not remove the old hardware as it is 15 degrees out and I am not sure that I could get it p ... (cont.)

Entry guard truth

The short arm has a B stamped on top. And it looks like a third arm in underneath. What part is this? I've replaced other versions of these before. Thank you?

Hello there. I have a big certainteed (9'x5' total) window with two flankers. Both of the mechanisms on the window are shot. What can I replace them with? Thanks so much!

I'm in search of both a right and left-hand (2) replacement cranks for two of our casement windows. I see where the part number S-1081-66 shows up in some of your posts but I don't see where anyone has confirmed that the part(s) you recommend did the job. Can you tell who the window manufacturer ... (cont.)

Hello. We have a customer with a late 1980s/early 1990s Kolbe & Kolbe double casement window unit that is in need of a new operator and some locking mechanism parts. Other than the finish, the unit is in great shape, and the because of the location it would be extremely difficult to replace with ... (cont.)

Hi. The size of the arm on the left is 3-3/4". The arm on the right is 11-1/2"Any chance you could give me a part number, cost, and approximate ship time?Thanks

Am looking for similar type "TRUTH ENTRYGARD OPERATOR 20544" .2 left and 1 right window handeler. Can u please suggest