Viewing all customer Discussions for:

39-205 Truth Folding Crank Handle, 11/32"

Hello! I saw a very helpful Swisco video about replacing this part. I have an awning window in my bathroom that will not close. When I would turn the crank, nothing would happen. It's difficult to determine what size dual arm crank I need to use. Also, when I took out the screen, I could see that ma ... (cont.)

I'm looking for these plastic covers to cover the casement operator. They don't snap in, but have double backed tape to hold in place and come in right and left hand versions. The crank handle is a truth handle with us pat 361490 5560082 stamped in it. I've found the handle on your site but not ... (cont.)

Howdy! My casement window operator arm is no longer attached to the window. It looks like I'm missing the pin that goes through the operator arm into the window. Can you advise? Many thanks! Stee

Hello!I am looking to replace my kitchen window casements that have stopped working correctly. My crank has a part number listed as 0PO5-7810 and the mechanism attached to the sill is 0P052020. I've included photos to hopefully help identify the correct replacement parts. I'd need to replace both ... (cont.)

We are working on a Frank Lloyd Wright Restoration and we are looking for this same handle/arm.Do you have this part in stock or tell me where i can find them.Thank you,Ron

I need a Truth RH 45136 window crank mechanism. See photo attached for approximate dimensions.Thank you,David

Peachtree window crank handle

Good morning. The crank handle spindle will no longer stay in the crank assembly. I need a new handle and crank assembly OPO52020 please. It has Roto stamped on the mechanism.

window will not crank closed. Opens fine. Plastic cover piece is cracked.

ok

Was wondering if you could help me identify these arms for replacment for my Casement windows. Thanks in advance

I need three of these. Four inch beige. 1/2 inch crank opening

Need the operator for a Marvin awning window. Our casement Windows use the 39-031. Arm 12.5" from pivot to pin

I'm looking for a replacement casement window operator for an American Integrity Windows part# HGO4 2007U. The rough distances between the symmetrical screws are 3 1/4", 2 1/2", and 1 7/8". It has about a 7-inch long arm length. The measurements are approximate until I take further steps to remove ... (cont.)

Hello, I'm hoping you can help me identify this window operator. I need to replace the whole part. The arms measure roughly 16 and 1/8 inches (not certain since I cannot close the window). The crank housing (spline?) measures exactly 5 inches wide. Thank you.

Do you have a recommendation for a replacement part for a OP05-7524-02? (See attached pictures). It has a 9.5

Hi, I?m trying to find two replacement window crank handles. The current ones are Weather Shield and they have the number 45001 on them. They are champagne colored. I have added pictures. Thanks, Tom

This hardware belongs to windows we bought 25 years ago. The windows were made by Pozzi who I believe sold out to Pella windows. Written on the hinge is the name "Entry Guard"I would like one of them but would purchase several to have on hand. I would really appreciate your help as the window can ... (cont.)

I need to replace two hand cranks and two black plastic slider guides for 1988 Weather Shield casement windows. I also need to replace a flip hand crank to a med 1988 Weather Shield casement window. Ed

Us.pat.0.247.270 - ca pat 2.248.439 3"- from screw hole - to screw hole Arm - 9" extended