Viewing all customer Discussions for:

26-378 3" Pivot Bar

The windows were installed in 2003, when the house was built. I need at least four, and would buy some extras for our other windows.

This piece is broken on one of our windows- wondering what replacement part to get.

Replacement pivot shoe and 2 1/16" true sweep lock I have need for 5 of the pivot shoes and 1 lock

On the coils I see 5.0 35" 5232208. The windows are Alenco. On the pin there is a 2. I need all parts shown in the photos to make complete sets for windows that need repairs made.

Good Morning, Please see enclosed photos. I need 4 clips and 4 of the post things that fit into the glide mechanism.

I replaced the windows in our house from Home Depot about 10+ years ago. The pivot bar on one of the windows broke from high winds and the latch not being secured. I've attached a picture from another same size window of the pivot bar. I'm hoping that you carry this part. If so, what would be th ... (cont.)

I need a replacement for this pivot bar as the one on the other side broke in half. It's about 3 inches long and has 111 stamped on it. It's for a PGT single hung vinyl window (see window sticker in other picture). Can you please point me to the appropriate replacement part on your site? Thank you. ... (cont.)

I'm in need of these window balancers and pins 4 of each, the coil looks to have a 6.5 on the end. Please let me know if you can help or need more information. Thanks Scott

I have found similar ones but not sure if they will work.

Hi, I'm trying to repair a broken window at our church bldg. One photo shows the "nameplate" sticker on the top of the window frame. The other photo shows two broken pivot bars and one broken pivot shoe (the gray twisty cam is split in two). The pivot block is between 1/2" and 9/16" thick. Is thi ... (cont.)

. Cant find this pivot bar within your catalog.The 2 are both broke. I saw one that was close but not exact. Thanks tony

I called last week to speak with someone about some replacement parts for my Simonton windows. I was asked to include pictures of the parts and the width of the balancer. I have included the pictures. I am in need of replacing the lower sash balancers on both sides of the window along with the me ... (cont.)

This is a bottom pivot pin in either side of the window. This is a straight bar with 2 holes. Please see measurements in pictures

The entire coil balance assembly has failed in different ways in multiple windows. Looking to replace them all. I think I have an S190 coil spring, but am unsure of the size. It's either a 6 or a 9 stamped into the spring, but I don't know which way is up! It's a 9 when looking with the screw hole a ... (cont.)

Hi, I need a Flared Pivot Bar. On you site you have ones that are 2 1/2 inches long and mine is 3 inches long. I am not sure if the length matters? Please let me know. Thank you-Rob

The spring is 1/2" wide

Hello, Need assistance identifying the correct replacement parts for a Simonton Double Hung 35.5 x 53.5 Contractor Series Window from 2005. I believe I have the correct Tilt Latches identified?#26-243 (LH) and #26-244 (RH) ? need 2 of each for top and bottom sash. I also believe I have the corre ... (cont.)

Hello, Attached is a photo of the pivot bar my windows have. I could not find an exact match and was wondering if you think you may have a close match that would work? Thank you very much

I am replacing the quick tilt assemblies inside one of windows that is completely destroyed. I need to know what parts I need. Please see pictures and advise. Please note that the casing around the springs have the number 4 on one casing and the number 8 on the other.

We need 40 window pivot bars