Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

2 channel balances 1st- stamp is 16 1 and is 17-17.5in2nd- stamp 28 3 and is 27-27.5 in

Hi, I need about 1 pair of 26 4 EW CMC 10 and 1 pair of 32 5 DW CMC 10.Thanks and regards,Manish

Greetings,We are attempting to repair Milgard single hung windows by replacing the counter balancers. Please see photo. Can you determine which part number we need or is the part number printed on the counter balancer itself? The windows are vinyl and are approx. 36" x 60".Our plan is to try to serv ... (cont.)

Hello, I need window balance channels for both sides, as both are broken and require replacement. I've attached a photo of the existing channels to help identify the correct replacements. Each channel measures 27 inches in length. Could you also let me know if I need to purchase the balance shoes se ... (cont.)

1/2" 27" long

Not sure which model the end pieces are

Please identify and locate replacement parts.

one of the channels has the marking 26-4 GH5 CMC 34, the other side has 26-4 GH5 CMC 75

Hi, please see attached picture and help me identify the correct part number. There is no stamp information on the old parts. The width is a little more than half an inch. The length for the metal portion is 27 inches. Thank you!

Hi Team! The spring mechanism that helps this window raise and lower has broken. I'd love to replace the pair of mechanisms in this window! See attached photo - and if you'd be so kind, let me know what parts I should order. Thanks so much for your time! Kevin

I need 2 balances 2 63 and about 5 takeout clips

I want to order these window balance springs as follows2windows for # 2040 Bsi ok2 windows for # 2020 Bsi og4 windows for # 2640 Bsi ojI need delivered to addressPlease call me with total I will give you cc info to pay and get order startedThanks Reuben

Metal Marking - 26 5 KT CMC 2 Metal strip length = 27" (without plastic ends) Appreciate if you can provide the equivalent part number for the above. Thanks!

Hi, I'm looking for a Specific window balance I want to make sure that they fit The numbers are hard to read, but it is 26 4 EN Caldwell

These parts broke and fell out of the sides of my sliding window. My window is still in place but no longer will stay up automatically when I open it. The parts have the numbers 2660 labeled on them. I don't see any more information on them.

Could you please identify the Caldwell of my non-tilt windows as shown on 2 photos uploaded?I measured the length of metal is 27", but the mark on the back is 26 3 EW CMC 10Thank you so much.Kevin

Metal channel measurement: 27". Markings: 26 4 HX CMC 11. No photo of end connection because the balance snapped. Looking for a quote for seven (7) windows, or (14) parts, since three (3) windows have failed in a short amount of time.

Balance from a 1997 manufactured home. Stamped with "Caldwell 26 4 CN". I have more pics if needed. Thanks for the help, Mike

Measurement is 27inches Marking is 26D USB I'm not sure what weight to use, but the window is pretty heavy. Is there such thing as too strong of a balance?

my tensioner has the code 26 4 GW CMC 11. Is that enough for you to identify the part or do you require pictures?