Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Hello again! Was wondering if I couldn't get your assistance procuring some balance rods. The only markings are the numbers stamped 2950. The weight of the window is 27lbs. Photos attached. Thanks!

I have four windows needing replacement balances, but I'm a little confused which S??? part number to select. Using the attached photos, can someone please help me identify the correct ones to order?

Serial number is imp 2950 bsi bn

Hello, i need 6 each of two different balances. I need 6 for a larger set of windows and they are labelled as 2940. Then i need 6 more for a smaller set of windows and they bare labelled 2930. All of the balances are 30 inches long and have the same fittings. Can you please tell me which model to or ... (cont.)

my unit is 1/2" width and 30" length (not including plastic parts) thanks.

Hello I pulled these out of the windows that won't stay up. The plastic pieces are mostly i Intack I'm not sure why they won't hold the window up. I pulled another set off a different set of windows and they are 26 ? threes. Should I go with a higher weight on this to a 29?3? Looking for your expert ... (cont.)

Do you have the balancers that are marked 29C USB 29D USB They are 31 inches in length.

Our windows are original installs from 20 years ago. Several of them open with misaligned and one or both of the channels don't seem to be engaged. Please see photos. Not all the windows are the same size. This is just one of the channels. Thanks.

I need new channel balances. the length of the metal is 30" and the width is 1/2". The marking reads 29 3 B.S.I 0L The window weight is about 20 lbs Window is non-tilt On the shopping section, it looks like either an S380 or S385 but I can't tell the difference

1/2 width, 30" long metal piece, marking "29 5 or S CT CALDWELL, Sash weights 22 lbb

Hi, The block and tackle is broken in this sash balance and I would like to replace both it and its mate as suggested on your site. The metal channel is 30" long by 1/2" wide inside by 5/8 deep over all. The only stamp I see is 29 5 AW CMC 2. I'm not sure of the window brand, there is NAMI on a stic ... (cont.)

Hello, I am looking for the replacement channel balance for pgt window with numbers 29-4 EI5 CMC 50

Metal is 30inches not sure of the stamp/sash weight. Winged on both ends.

Hi,We need to repair the channel balance for all my 20 windows, and I'm not sure what to order. Can you please help me out? We leave in South Florida and the house was built on 2002I have different sizes, also one window is (29 9 JT CMC 2) Looking forward to hear from you soon Thank you Raiza ... (cont.)

See the pictures for 30 inch balance. Please advise the option

I am looking for channel balance (2) and top sash guides (2) to replace on a sliding window (window does not tilt and slides up and down). The channel balance is 30" (metal to metal measurement). The code on the channel balance is 29 9 FV CMC 2. Can you specify the channel balance and top sash gu ... (cont.)

Hi, Attached are pictures of my damaged channel balance. Can you help determine which channel balance to get. Thank you, Mike

I am looking for nine sets of replacements. Would you let me know which one is the replacement part and I will order it

Nuair windows from about 200730 inches height29-5 FA2 CMC 13 marked on sideI need two.Thanks,Bill

measured length: 30", width: 1/2", and marking code: 29 3 FW CMC 4