Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Tim, thanks for the reply already. Here are pics of my channel. Shoes are riveted in place; but, bottom shoe measures 1 3/32". Channel is 30"; and, sash weighs 29.8# Ron

Good afternoon: I have a 30" channel balance with 18.2 lb sash, 1/2 inch channel. The plastic bracket that goes into the top of each side of the sash (which catches the channel balance) also needs to be replaced. The window bracket is 7/8 of an inch across the top. I have attached a few pics ... (cont.)

the part is marked 2940. Can you take a look at my images to identify the part? We are looking to sell the house, so not looking for top of the line.

Soon to be repeat customer needing help IDing replacement part window sash spring shown in attached photo.

I'm attempting to repair several windows. I am unsure how to correctly identify the caps or whether to replace the entire tension bar.

Not sure about stamp option for nuair window balance part. Only marking on original is "29-5 ea2 cmc 5".thanks

I have attached images of the window balances that I need replacements for. Please have some one call me when you have time.

Hello: my balance is stamped "13:10:59 05\18\04 UNIQUE BALANCE 29B". How do I find out the sash weight range option? Thank you.

I am replacing the whole unit including plastic ends, Can you recommend a replacement unit?

Hello! One of the window balance for my windows is broken. I just took a picture for the mark on the window balance. As you can see, the mark shows "29-3 ID5 CMC 54". So, the correct window balance that I should purchase is "30" Series 385 Channel Balance", right? Please advise. Thanks ... (cont.)

Hello - I need to purchase a number of new balances for the Kinco windows that were installed in my house back in 2003. I'm reading a post from someone who had a similar request recently, so I hope I'm providing the information you need to help me identify the balances I need. My current b ... (cont.)

Hi, I am currently looking for Milgard window channel balance replacement parts for my house. I have attached some photos for your reference. The length of the channel (not including end pieces) is 30". The channel cross section is; channel width 9/16" & channel depth is 5/8". I have included phot ... (cont.)

30" L, 0.5" W, 0.5" D Pics 2 and 3 are bottom shoe. Pic 4 is top. Would need to order 2 :)

I need help identifying the window channel lifts. Many of the parts look very similar to me. I have enclosed 2 pictures of the ends of the one surviving lift. The lift is 30" long and 1/2" wide, the window weighs approximately 26#

Measurements Long 30in (metal part) Wdth 1/2in (see picture) Marks/numbers. 2920 D BSI

. I am looking for a 30 inch x 1/2 inch channel balance for a Milgard Window H-C40-54x90.

Hello, I have these balances on several windows. I have various damages to the upper guides, the window sash guides/balance hangers, and balance pulleys. I'm looking to replace all my channel balances but the stamps aren't listed anywhere I can find. The stamps read 29 6bsi and 23 9bsi. I have ... (cont.)

What is part number for this and do I need to order the guides support?

Single hung Total window height 61 inches, width 51 inches balance has number 29-5 CA2 CMC 4

Decided to replace broken channel balance, both sides with 19-005 and 15-004 but could not find markings for weight range is that weight approx of window and with a series fully assembeled do you get a right and left. Thank you