Viewing all customer Discussions for:

26-040 Pivot Bar, 3"

Do yo have this type of pivot pins. I need 2 of them. I assume one part will work on either side. Thanks. Tim

I'm looking for a replacement for the plastic housing piece with tabs for this pivot bar. Thanks!

A Reliabilt tilt-in, single sash, double glass window measuring 50.5" x 35.5" has 2 pivot pins measuring 2.5" and 2 coil balance with pivot shoe are damaged beyond repair. All damaged through rough handling. The window closes and locks however the bottom portion of the sash is free due to broken piv ... (cont.)

Not sure what they are called. Looks like a type of pin for upper sash of Gorell windows. They have rusted out and need replaced. They are Armor Impact Plus Hurricane windows. Any help appreciated

Dear Swisco: I have removed a pivot pin assembly from Jeldwin double hung window. It has a reference number 985 2-A on the plastic piece. It measures Plastic only2/1/8 " in length 2 9/16" in height and 2 9/16 in width. The measurement that is the length doesn't include the pivot bar the fits int ... (cont.)

This piece allows the tilt to the window while holding it into place. I need to order some of these.

I need pivot bars for Jeldwin windows as shown above and also need pivot bars for Jeldwin Windows 15-087. 15 each

There's a spring on the top of the side railing. But on the bottom there's this "Pivot-lock guide" that makes it stay up while open.

Spiral Balance Pivot Lock Shoe

Trying to figure out exactly what parts I need to replace the parts attached, that are located at the bottom of my window, acting as a pin and counterweight mechanism to keep the window open. My windows are manufactured by MI Windows.

Looking for window brand/part number since several parts are affected/ broken sash cord, broken frame corner, broken tilt latch, jamb liner/balance parts damaged, missingAlso sent an email msg- THANK YOUJerry

I can't find a video that has my actual issue. I have a tilt window that won't close properly. The top sash drops about 1/4 inch so the locks don't line up, easy to deal with but now when bringing the bottom sash down, the entire sash sits to the left so there's a gap at the top right of the sash. A ... (cont.)

Looking for this part, I cannot find a manufacturer label

I have a Gorell tilt vinyl window and the pivot bar snapped off when removing sash. The bar measures approx.3" long and about 1" from the end, it has one single screw hole. Everything is rusted. I have replaced the mounting bracket wit your 6-o24, 15-o87 coil housing pivot, 15-086 tandem coil housin ... (cont.)

This pivot bar was removed from an unidentifiable tilt in window. A majority are completely rusted away. Can you identify it? I would like to order 12 with the screws.

I have more photos but can upload . Windows are Imperial Window. Two sizesName: Minh

The attachment pivots are cracked and the sash bottom broken. Are these parts field replaceable ?

Hi guys, Well I ordered the 900 series balance system and pivot shoes Product Code: 15-134 swico. The problem now is, everything fits , except the cam hole, it's to small, the pivot bar is a little bit bigger so it won't fit in. So what are my options? New pivot bars? Or new pivot shoes?Best regards ... (cont.)

I need help identifying a window balance, it looks like a 795 series which measures 15 inches long .562 inch wide and .530 thick. It has 14-3 stamped on it. I also need the tilt latches which measure 2.385 inch long by .680 inch wide measured at the top by .420 inch deep. Last the pivot bars which m ... (cont.)

This pin has a groove and is 3" and gets screwed into the lower corners of the window to rotate for cleaning.