Viewing all customer Discussions for:

26-040 Pivot Bar, 3"

The brand of window can not be determined. I need to order the assembly shown in the photo? Can you help identify what i need just by the attached photo? Thank you in advance

All I see is a #4 on these plastic pcs.

I need (2) sash pivot bars that fit the pivot lock shown by the attached pictures. An additional picture shows the tags/stickers that were attached to the windown. Please call me at any time for ordering and any installation advice you may offer. Thank you much! Steve

Im trying to help a customer and im having a hard time determining which part to order. I believe is the 15-154 all the dimensions match up . I was just trying to determine and am second guessing myself. And information youre able to provide is greatly appreciated! Thank you !

Need part id for this. Has pat# 5.353.548. Approx 4" tall 1" wide. Tension seems to work ok, but upper housing broken. Also I don't see cut out to remove. Is housing simple to replace with that coil spring tension. A video reference would be appreciated. This window is traco series tr4200 dh ... (cont.)

I have brokern window balance parts and I can't seem to locate a name or a part number. This is from one side of the window. The both sdes are the same.

I need to replace 4 pivot shoes for my tilt window. What replacements do I need?

I will need coil supports also. Thanks

I can't find the brand of this balancer.

Can you please assist us with identifying these specific tilt bars? We are unable to find an exact match on your website.

Hi, I need to replace a pair of coil balances/pivot shoes as shown in the pictures. spring is marked 730x. Window is a american craftsman silverline model 8500. 28x58" the pivot shoe has a handwritten "7" on the back side. The window sash weighs approximately 11 pounds. Please advise what part n ... (cont.)

I believe my windows are Simonton or CertainTeed. Approximately 25 years old. Any part numbers are absent/illegible. Bottom sash weighs 20.4 pounds. Require part numbers for replacement roll springs, supports, bumpers, lock shoes, and sash pivot bars if required. Photos show installed/broken, ... (cont.)

The pivot bar is 3" long with a about a 1/4" offset as shown in the pictures. Also, it is about a 1/4" wide and about 3/16" deep excluding the offset. The surface latch is 2 3/4" long as shown in the pictures and about 3/8" deep by about 3/4" wide. I am looking to get these in both left and right si ... (cont.)

Hello, I am looking for a couple of balancers (32c), Pivot bars that fit to 1/2" pivot shoe. Please see attached photo of the window. Pivot bars already rusted and can't find the right parts replacement. Please let us know if you have available parts for my window. Thank you

BIu

Please let me know which pivot bar would work.

Hello: Hope you can assit me in getting the parts needed for my window. In the Photo the spring is the broken one on the left , spring on the right is good as far as I can see. The item below the broken spring is what I call a T Bar, which is goes on the bottom of the window so you can tilt the wi ... (cont.)

Coil springs in no-name vinyl window stopped working; window won't stay up. They are visible ouside of the enclosure on both sides, unlike other working widows in the house. I'm not sure what I need to fix the window. Based on the attached pictures, can you tell? If you need better pictures, please ... (cont.)

hi ...can you please tell me which pivot pin I have in the photo. thank you

The part is 2 inches by 1 1/4 inches by 1/2 inches thick. I have included a picture of the torsion bar that it fits into. The part I have is all plastic with a metal top plate where the torsion bar enters the shoe.