Viewing all customer Discussions for:

S395-24 24" Series 395 Channel Balance

I found markings on my balances and would like to order the same ones. Could you please help me identify the exact type? Thank you.

23 5 AX CMC 1 I also need a set of balances for a single pane single hung window 31 1/2" height, 45 1/2" width can't see the actual balnce of this window without taking the window apart. looks the same as the 23 5 AX CMC 1 but I am sure it is a different size.

Cannot find exact direct replacement for PGT window. Can someone please assist?

Channel length 24" 2390 FG B.S.I. 26 Manufacture P.G.T. Year unknown Need 2 for sure, 16 depending on cost

Hello, please see attached for the balance beam I'm looking to replace

I need to replace this 24" part. I have the plastic inserts that go in the window. Thanks Joseph McClure

Greetings,I need to replace two window balancers for my single hung, no-tilt windows, circa 1990. They are marked 2320 and have the ends as shown in the attached photos. I need help selecting the correct replacement parts. Thanks,Brad M

I'll need to buy four 2040s, two 2030s, and four 2340s. Top and bottom inserts are identical (or at least look identical) on all of them. Top insert has wings but bottom doesn't. Thank you!

Trying to figure out what Series window balances I need. They appear to be Viking windows. I think based on my research that they may be S395s. But I don't know what weight rating to get because they don't appear to have a stanmp for that and I don't have a scale.

I need to find a replacement balance rod for several windows. These are PGT windows on my house that was built in 1996 and several of the plastic parts or rods themselves are starting to break. The windows just slide up and down, they do not tilt. The rods have a stamp of 23 2 DP CALDWELL ... (cont.)

I have several non-tilting channel balances to order & replace and believe these are Series 395 Channel Balances. However, due to the quantity I want your professional confirmation so I order the correct balances. Metal channel width is 1/2"-9-16". Markings on 3 different sizes are: 23 4 DQ CA ... (cont.)

I have a non tilt channel balance with markings as listed below I need to replace both on the same window 23 9 FW CMC 10

This balance is 2ft long and half inch thick. It fits inside of our living room window.

Can you provide two balancers measured 25" long? There is a Caldwell written as 23 3 DL Caldwell on it

Hi, I measured the metal part which was 24". can you help me find the parts for replacement? Also which options should I be choosing? The numbers on the old one shows 23 4 0715 VBS. Does that mean I should be choosing the option 2340? Thanks, Mike

23-9 JX CMC 7 29-9 this balance also has a PL imprinted on it I did enclose pictures to help out. If you need more information please contact me. PGT Windows, about 20 years old

Please identify this item. Stamped on balance 23 3 IW CMC 11

The Viking window metal shaft is 24". I'm looking for the correct replacement for my window.

I need at least 2 new window channel balances for non-tilting vinyl windows. The example I took photos of is 24". I need to identify this channel balance.

The balance says 2320 JP It's for a PGT 34" wide x 24" tall sashSingle hung non tilt window The metal channel measures 24" long x 1/2" wideAlso need the clips to remove the sash and balances.