Viewing all customer Discussions for:

26-244 Tilt Window Latch, Right Hand

Tilt latch for Barber and Ross window with length of 2 5/8 inches and width of 11/16 inches and thickness of 7/16 inches.

I think this is bf rich single hung window..need parts..see pictures..

Hi there - can you pls help me to identify what parts I need for the following? Label on window is attached to identify the window in question but reads series 3700 aama/nwwda 101/i.s. 2-97. The parts I need are the closing/locking mechanism, the piece that holds the string for the window pull in ... (cont.)

I ordered 2 26-390 and 2 26-391 thinking they were the same as mine but I was wrong with my measurements. Mine were shorter and thicker. Mine is the one on the right. Could you please give me the correct part number if you carry them . Thank you .

Do you carry a replacement for 1998 Ellison Series 1600 Window Latch?I need about 10 pair.Regards,Keith

ALENCO WINDOWS (i believe vinyl) ABOUT 11 YEARS OLD....SINGLE HUNG

Need help with balance for loweer sash parts

Having a very difficult time finding replacement tilt latches. Any help would be appreciated. Thanks. Dimensions appear to be 2-5/8 x 11/16 x 3/8 NMAI Validation Sticker says Code: V-072-2, Spec: DH-R20/R35, Series Trendsetter T-300, MST: 4060/3050

Farley Windows installed in 2006 by builder/developer. What is the best option for the Tilt latches which are slide in type. Also the sash pivot bar is nylon. Photo is part of the pivot bar. What is the best replacement option and is the pivot bar enough or do I need other parts. Thanks for your ... (cont.)

We have 8 older builder grade windows with no identifiable markings These are the parts. minus the spring that need to be replaced Thank you We are a property managment company

I'm looking for replacement parts for the above pictured windows. Anyone know where I can locate?

old vinyl windows- broken sash latch allowing air infiltraion between upper and lower sashs (left side latch)

To whom it may concern : The 22-year-old windows in my condominium need some parts. I hope you have them. I need the side latches that allow the windows to be tilted inside for cleaning, and also hold the windows in place. The latches are 2 5/8 inches in length on the top, though they might look l ... (cont.)

Need tilt latch but not sure manufacturer of window

Hi this part, the latch that allows you to have the window pull in to clean is broken trying to see if I can order replacements Thank you. Courtney

Hello, We have put together a hardware order but have one part that we can not seem to identify. Please see photos of drum roller attached that we need to ID. We would be looking to order Thirty (30) of these. These would be used with Swisco series 152 coil balances for 9 lb. sash. ... (cont.)

I am looking for a replacement part for some vinyl double hung windows. The part is in one of the two photos. It is the bottom piece that the window locks into with the gray pegs. I also included the only markings on the windows. Thanks Derek

I am having difficulty removing the spring housing/vinyl cover from inside track of window frame. Cannot tell if there were one or two springs inside. Springs came out in broken pieces. Both sides need to be replaced. Need help choosing coil spring type/ # of springs to order. Your Series 165 stainl ... (cont.)

Need a lh and rh tilt latch. Right hand tilt rod? Or tilt pin?

First, sorry so dirty in the pics. Trying to repair rent house windows. The latches are broken and the shoe is stuck in the bottom of the one. The only marking I can find on the window is PRISM. The best I can measure the latches are 2.5" by a hair under .75"