Viewing all customer Discussions for:

15-005 Winged Channel Balance Shoe, 1" Depth

Dont see one that you have that has the top I have. My bottom is also 1inch in depth. Looking for help in finding a 36in bar 3540 with top and bottom brkt as shown.

no numbers or markings the metal channel is 1/2 inch inside width 5/8 overall depth 24 inches long not including plastic bits windows are 24 x 50( heavy)

Not sure what 15-XXX it would be. Thanks for the help.

I have some old wooden sash with broken balancers. I'd like to talk to someone about easiest way to reinstall balancers. Sash won't come out until I remove wooden trim stop that retains sash in frame. It won't fit over balancers so must be installed in sash to install. Any hints for holding balance ... (cont.)

Hello,Please help me idnetify the part I need to order from you. I will need 4 balances to begin, for one double window.Thank you in advance,Jebran

33 1/4 INCH 3230 31 INCH 3030 30 INCH 2930 28 1/2 INCH 2830 Order #3174215 my last order THE ENDS ARE THE SAME also replacement parts for the ends , i may be able to repair some. one one of the rods , i may just need one. will if have to order a pair , let me kno

Please can you help me find this part please. Need it to fix my window

The clips in the frame are plastic. Tried a newer balance rod but does not fit well in the channel. Top broke. The new ones had slimmer heads..

Looking for this part. Hope you can assist. 1975 aluminum windows. you have a similar part w/o the side wings measurem are h 3/4"w 11/16" d 9/16" wings width 1" there is a fight and left side part

Traco 24 inch balance with the inscribed numbers of 23DSr/i38.

Not sure which model would replace the channel balance The length is 26" The Top no wing The shoe is 1" with wing not sure which would best replacement.

1/2 inch by 31 inch balancer for 28 pound Milgard window.

Hello, I need to replace a set of 28in window balances but I can't match the top and bottom fittings. The top is non winged while the bottom is winged with a depth of 1in. There are some models on the site that appear close but not quite exact in terms of top and bottom fittings. Please advise on th ... (cont.)

Windows are 52"W x 63" H.Numbering on block and tackle balance 23 DS. 3.S.1 and RR 39metal end to metal end is 24"Correction balance is stamped 23BD. BSI and RR 39

In need of 6 window balance

Lenght is 24 inches. Need to replace balance both sides impact windows. No stamped identifiers on parts.Windows are PGT Impact

I am in need of 4 (2 ) for each window and 4 clips.

I need to replace both balance springs and the guides afixed to top of windows also I will need two replacement Pan Am Take Out Clips. thanks for your help Tom

Attached are photos forwarding to see if you can help ne to secure a proper fit for a non tilt sash window. I am a homeowner and had bought a part (door Lock) from you a few years ago and was indeed happy with service and part. The measurements per you instructions are : Lenght 24 ins, and Widt ... (cont.)