Viewing all customer Discussions for:

26-452 T Bar Pivot

my pivot bars that I am looking for are 2 1/2 inches long. They are tapered down at the very last 1/4 of an inch.. they are 5/16 of an inch wide down the body of it and 3/16 of an inch thick . The first hole from the top end of it, which I am referring to the T at the top is 1 3/16 of an inch to the ... (cont.)

I think the pivot bar is 26241 not sure which shoe cam it is. It's for appleby double hung tilt in windows from 2005.

Dear all, I need replacement pivot bar for my windows as shown on the picture. There are no markings on the piece. Thanks a lot! Dirk

I found the pin goes from window to Pivot Locking Shoe, broken !! Is this something I can order from you guys?? Check the attached pictures please

My window will no longer stay up when we open it. The top window operates normally. I am not sure what parts I need. If the pics are not enough I can take the shoe out and look for a part number and measure it. The problem is this is a rental and Im not there at the moment.

can i get some help

Hello, Would you please take a look at the attached pictures and let me know the related part #? Best, Chris

I am looking for replacement pivot bars for some windows in an apartment building. The windows were installed in 2011 and may have been manufactured by Crystal Windows, but I am not sure. The bars and 2.5 inches long, 5/16 inch wide, and have a 7/16 inch wide T at one end. The screw hole is locat ... (cont.)

need 12 each 8321DH H-R40-44X60

Good morning. Can you please suggest a replacement. Length: 2 1/2 Width: 5/16 Width of T top: 7/16 Distance from top to center first hole: 1 5/16 Distance from top to center second hole: 1 13/16

does this part number accept a screw 2" in from the exposed end?T Bar PivotProduct Code: 26-45Picture of pivot pin , need 8Also need 4 balance assembly

I need to order these parts I'm looking for the best replacements for them

Pivot bar for Lockheed window. 3 inch, about 1 inch between screw holes. Head is 7/16

Would like confirmation of the balance spring needed based on the photos. I did not remove the existing hardware because I will need to notch the track to remove, which I will do after receiving the new part. Current spring width is 3/4" and weight of sash is 16.0lb. Based on the part description, p ... (cont.)

This is a bottom pivot pin in either side of the window. This is a straight bar with 2 holes. Please see measurements in pictures

Window will not stay up. The plastic cam housings and pivot lock shoes have cracked under pressure and broken off. I believe part of what I need may be #15-087 balance coil. Not completely positive that this is correct. The window pane measures 16.5"X31.25". When I opened and tilted window pane to ... (cont.)

Do you still offer these? It is 3"x 1/4".

Hello, Attached is a photo of the pivot bar my windows have. I could not find an exact match and was wondering if you think you may have a close match that would work? Thank you very much

Trying to find a replacement for broken pivot pin. Can't find any manufacture markings.What is the thickness, width and if possible, the width of the "tee" part. It may not be the best fit but if the numbers are close, it's better than nothing.