Viewing all customer Discussions for:

39-451 Encore Truth Operator Cover and Handle

Hi! I have casement windows and need to replace the metal crank mechanism. Not the white hand crank but the metal piece, some have completely rusted out. Attaching photos. Please let me know if you can supply this part! Thx! Bryan

My window will not close properly after I open it. I need to replace a part but do not know which part needs replacing. Could it be the one with the teeth ? I am attaching a photo. Please respond as soon as possible as winter is on its way and I would like it fixed before the snow flies. ... (cont.)

Looking to order a operator for my casement window thanks I attached a picture

Need help so I can replace crank arms for windows. Looking for parts

I need to replace my Hurd window opening mechanism. It is stamped with the code 14D200P and on another rod Truth. The handle is to the left center of the crank and the window opening. The window opens from the right and seals to the right side of the casing. It is hinged on the left side of the wind ... (cont.)

Need a new cranking mechanism. Not sure what type this is. It is centered in the middle of my window. Any help would be highly appreciated. I found a number stamped on one of the arms upon closer inspection, 31881. I'm not sure if that would help

Please help me identify this operator as I could not find it in the catalog. The exterior screw holes are approximately 4 1/4" on center. The swing arm is approximately the arm that attaches to the sash has a plastic glide and not sure what dimension you need but the ruler is on it. The inside curv ... (cont.)

I've recently purchased one 39-239B : Encore Awning Operator, Sill Mount. I'm trying to remove the original white cover. Is the cover supposed to come off of the original Truth Model 41013? The date code on the original is 08/04/00. If the original cover cannot be reused is the correct replacem ... (cont.)

Does anyone know where I can get this part?

My window crank is broken. I think I probably need all the hardware?

I have 12 severely corroded dual arm, pivoting (not sliding) vinyl casement window operators that need to be replaced. I am adding pictures. The arm from the operator mechanism is 3.5 inches long, the upper pivoting arm is 5 inches and the lower pivoting arm is 7 inches long. Hope you can help.Laure ... (cont.)

Photos showed broken crank from lefthand Milgard casement window. Crank shaft snapped. Installed photo is from identical mirror image right hand window. Window was installed in 2006, consistent with the date stamp on the part. If pictures aren't clear, there are eight mounting screws on the base ... (cont.)

Our 2 crank windows won't close if they have been fully opened. We can't find a left and right replacement system on your website. We have attached a photo. Please advise

I need to replace my window operator but not sure of the correct part number needed. Please see pics. I was on the Swisco website and found possible replacement parts: 39-239B or 39-239C. These windows were installed in 2004 Please advise. Mahalo. Russ

Need replacement parts related to the extension arm for 2 Cascade bathroom windows. See attached photos.

Looking to identify this operator for an awning window we are repairing. Thanks!

Looking to replace the crank handle, operating arm, and both the arm and track in which the arm slides into and glides vertically when in motion. If possible stainless steel as we are located in the beach area with a lot of salt air. Thank you.

We are looking to order a window operator with crank Truth brand in white. Please let me know if you have this available.Thank you,Joanne

Hello, Can you help identify 2 parts: 1) crank mechanism - for one of my two windows it's missing 2) handle for crank mechanism - for two of two windows I need replacement Thank you.