Viewing all customer Discussions for:

33-070 5/16" Shoulder Screw, 1/4"-20 Thread

Hi, This is from a Florida 50s era home. It is right-hand position. Has a worm gear insert that falls out. The handle crank is attached to the worm gear.

Aloha,I have what appears to be 39-061 right handed operator.I've ordered but wanted to confirm this is looks right.I've already ordered washer 33-070 to replace missing ones and they fit perfectly so I'm hoping 39-061 is the right one.Thanks in advance for your help!Mahalo,Erich "Sharky" Schrottke ... (cont.)

Part for an old jealousy/awning window

I need 1/4"-28 shoulder bolts and plastic bushings for Woodco window crank arms.

Would you happen to have these screws in stock? If so, I would like to buy about 2 dozen.

I, too, have LEMCO Series 30 awning windows. I am looking for the LEFT HAND crank.

Hello, I bought an old apartment (1983) with original windows (uggggg) the majority of them work fine, they lock but there are a few that only one side the pin does not lock in the hook. They both seem to be in the right place compared to the other side that works so I am not sure what the problem ... (cont.)

Attached are pictures with dimension of operator I am looking for, need between 10 and twenty but want to get one first and make sure it works

39-252 looks like it may work. The distance from the top hole to the bottom hole on mine is 5 1/4"center to center, so is yours. The distance from the one bottom hole to the other is 1 1/8" center to center, so is yours. In the second photo the arm that attaches to the window is 1 7/8" center to ... (cont.)

Was supposed to have a 3/8 inch hole

Need to replace this with screws . It originally had a rivet that my husband had to pop out to take it off.

Hello! I have ten of these windows that are showing their age. I've looked everywhere for any type of markings and I can't find any. I saw a video where a guy replaced similar windows on his Airstream and said the model number is usually on the lower left exterior, but mine has nothing. I need ... (cont.)

How can I repair this arm on my Nuprime window operator

Similar to the customer who posted back in sept. 2017, I am in need of a replacement for my 1717r awning crank. After taking all the dimensions I purchased your 39-025.... but it was a no go ( picture attached). I would greatly appreciate a call so that we can figure out which one I need to purchase ... (cont.)

I need a few operators, can you ID ??? Thanks! David S

Screw is 1/4 in diameter and 5/8 in length below the shoulder. Course thread (5 turns looks like in the 5/8"). Shoulder is minimal (about 1/16"). I need about 20 on them. Thanks!

I'm trying to find these operators. The top to bottom screw holes are 5-1/4" apart, center to center. The bottom screw holes are 1-3/8" apart, C to C, and the outer arm is flat, and 2-7/16" long.

I need the shoulder screws: counter sunk ,fine thread, phillips head with shoulder that is used to hold the bar in place that open and closes the window locks at the same time. lost one so need order replacements

I need to find the clear plastic connectors (bushings?)to be able to connect the crank with the window levers. If it matters the crank is 4 1/2".

Hello. I am repairing awning windows in 8 rental units and I need help in identifying the necessary parts required. I've attached several pictures. I believe the cranks needed are 39-017 right and 39-016 left. I will need 34 cranks and the ancillary parts you recommend.