Viewing all customer Discussions for:

39-015 Roto Gear Window Crank, 25-1/2"

Hi- we have a bunch of window cranks that have broken. We previously had a handyman replace, but the part was too small and flimsy. it looks like your product would be a better match. i have attached pictures of the original crank. I also wonder if the thread is too worn down... the product that l ... (cont.)

This is mounted to the bottom center of my window. I have to remove a wood piece over this operator to remove it. The window is old but in great condition and I would like to keep it. The operator has the number 45002 on the bottom by the screw holes and 30897 on the arm parts.

I need to replace this part to a Peachtree awning window. It looks like the Roto Gear Window Crank 39-015 has the right measurements. Will it be compatible? And what handle would work with it?

I am looking for a window crank Truth Hardware 25-1/2" Dual Pull Roto-Gear Awning Window Operator part # 30897 bronze color 13.5 shorter bar attached to window.

I need to replace an awning window operator that has stripped threads on the insert that holds the handle to the base. The operator is marked "Truth" and I believe the model is 11-14. The operator arms measure approximately 25". Thanks

The end of the handle actually goes into the hole, it does not wrap around a knob. The tip that inserts might be about one half inch in length or less.

Hi.My crank froze when trying to close the window. With effort I could reopen it but the mechnism doesn't work the other direction. Reuten appears on the crank, Truth and 30897A on the arms, Truth on the crank housing and 45301. Made in the USA, USA PAT4505601. PAT.CAN.1986. Do you have the replacem ... (cont.)

The retainer and female part have stripped threads. The arm is stamped "Truth". Can you identify the model and supply replacement parts or the whole unit?

Both window sets are Marvin Windows. The top photo is one of two in a set installed about 1998. The second photo is one of two in a set install when the home the home was built in 1988. Other that the different mechanisms, both sets are the same size sets of two windows. The cranks for the older ... (cont.)

I can't open the window this is the best picture I can get and I need 9 of these

Do you have this part . The crank says loewan on it . There is a worm gear and crank not shown here's.

Need to know which one to order

The crank just turns and will open but not close the window. Eventually the corkscrew will come dislodged. Dimensions are 13 1/2" where it attaches to the window and the dual arm at its' widest before closing the window is approx. 25".

Looking for thexample part on the photo

The retaining bushings are coming loose and I cannot tighten them. Do you have a tool for this?

i have 2 bathroom windows (approx 28w x 18h) that i removed the cranks from, due to rust (they were frozen and open 1-2" year round). My neighbor got parts from you for a similar window, but his dual arm crank looks smaller (39-140). I'm guessing i need the 21.5" size (39-083) to match the photo i s ... (cont.)

Hello, Looking to replace my window crank mechanism. The arms measure 25" across when closed. The part attached to the underside of the window measures 10". There is no identification on the part But I am fairly certain that it is a Fiberlux brand. Thanks, Mark

I need to replace this operator

Hi the window opening mechanism stopped working on my casement window. I couldn't find any identifying marks to tell what brand it is. Can you help please? Thanks!

Hi, the screw mechanism is no longer working for our casement awning window. Could you help us figure out what we need to replace? Thanks! Elizabeth