Viewing all customer Discussions for:

39-015 Roto Gear Window Crank, 25-1/2"

Regarding P/N 39015, when you order the operator, is the handle included, or, do you have to order that separately?

Hello, need some help finding the replacement crank mechanism for a few windows where the cranking gear has come out of socket. Thank you.

I SENT AN EMAIL WITH THE SAME INFO TO YOUR CUSTOMER CARE DEPT. THEN i SAW THIS SO YOU MAY GET DUPLICATE QUESTIONS. THE THREADS THAT HOLD THE BUSHING WHERE THE HANDLE GOES IN ARE STIPPED. STRIPPED ON THE CASING NOT THE BUSHING, MAYBE THE BUSHING IS WORN TOO.

I have a window with the awning crank mechanism that is broken at the handle and I need to replace the entire crank mechanis. I measured the window crank with and it's about 20 to 21 inches in length and I see that your picture shows that you have one for 25 1/2 inches wide I'm just wondering if yo ... (cont.)

I need assistance in replacing my awning window operator. The operator says TRUTH with an arrow on the arm and on the casting. On the arm is the number 30897A. On the casting is the number 45301. I cannot find a manufacturer anywhere on the window. The operator works fine to open the window. ... (cont.)

I ordered a new operator for my window. How do the retaining screws come out without destroying the bottom of the window seal?

I need 8 of these operators. Can you identify? 4505601

Handle has a part #45012. The locking screw threads are stripped. Also, how do you get the mechanism out of the window frame, as I don't see any screws from either side.

A very helpful associate of yours suggested that I send you a photo of what I need. Front mounted bronze with stainless arms double hung opener for my window. The piece attached to window it's self is 13 1/2 inches Long arms are 11 1/2 inches And short arms are approx 6 1/2 inches Please get back to ... (cont.)

The crank mechanism on the window won’t close the window. It appears the threads in the housing are stripped. See photo. What is the solution? Thanks

Is this item Truth operator #11.14. If not, critical information is needed for the under sill dimensions. From, and above the frame mounting surface ,the clearance restriction to the sill cover is 3/4". This is the existing mounting conditions and is a PDF drawing on Truth's website. If your op ... (cont.)

Do you have a window operator like the attached?

The operator I have looks a lot like your 39-348. The mounting holes are different. The casting has the name Standard Thompson and the ends of the arms have metal "buttons" that ride in the channel. The distance between the buttons is 34 3/4".

Hi there , I need 2 left hand and 2 right hand operators

These are the only parts I have the window is 28 inches wide. It is an Andersen window I guess I would need all parts to operate window maybe we can retrofit

I have a Peachtree casement window that doesn

It's approximately 26 in wide when closed. Crank came out. Do you know which operators would attach to the window like the current operator and not to the bottom of the window?

This part came out of the hole where the handle attaches. They just spin around and won't open or close the window. What can I buy to fix it? Thanks Lee

Crank # 45054. 16" . It's a Loewne awning window. Thank you

Part 30092 Can it be ordered?