Viewing all customer Discussions for:

Door & Window

1994 norco double hung windows. Need replacement balance tubes for jamb liners

Hi, I ordered the 39-031 as I had purchased it previously for another window and it worked fine. When I went to do the replacement on another windor the link arm is too long. The old link arm is 2 13/16" whereas this one is 4 7/16". I looked at the 39-155 which has a shorter arm but it is still 3 13 ... (cont.)

trying ro find sliding glass door handle thats 6 1/4 from hole to hole

I need channel balance and top sash replacements for my non tilt window. The existing balance metal only length is 28" long and 9/16 (1/2") wide. It is marked 2730. My window sash is 15 lb. The top sash guide appears to be a 5/8" product code 18-008 or 18-008H

Do these units come as Left or Right? I have side by side Simonton Casement windows with cranks operating in the opposite direction. see photos. Thank you

15" Series 385 Channel Balance, 1420 for Option Will This Fit? Please verify. Thank you. See attached photos.

I'm looking for replacement rollers for the sliding door in my camper they are stamped with Ultra I was not able to find them on your site.

I have a casement vetter window that the spine on the crank is striped. When facing the window from the inside the hinges on the the right side . The lock is on the left and the window opens from the 9o clock to the 12 o'clock position ( 90 degrees). There are two series of numbers stamped on t ... (cont.)

Door came from home depot. no markings on door or parts

Needing to replace the glaze in most of the windows. Not sure what I need to order.

20 4 LU CMC 1 21" x 1/2" x 3/8"

I've searched far and wide for a replacement shower door bottom seal (see attached photo) but no luck so far. By any chance do you have this one? I don't have any markings on the shower, shower door, or shower door drip rail. Thanks.

Hello, It looks like we need a new rail for our patio door (cmhc-7615). Is it something your company can help with?

Hi do you have the cover for the window crank 39-146, separately? Thank you

Our Pella bottom rollers are sticking and need replacement. Do all Pella doors use the same bottom rollers? Our doors are probably 10yrs old. I would rather not remove the door until I'm ready to perform the install but if I have to in order to determine the specific type of roller we can do that. ... (cont.)

Hello, I'm needing 2 sets of replacement rollers for my patio doors.There is no marking in the doors or hardware. The wheels are nylon around metal bearings. It is a single wheel. Wheel 1 1/2 inHeight down by screw 1 1/3 to 1 3/4Over all length including wheel 31/4 inWidth 7/8 in Please let me know ... (cont.)

The plastic insert to the window crank has stripped. Seems like a fragile part. Please recommend where I can find plastic replacement part.

How do I go about removing the window from the rail. Looking to swap them with an uncracked window from another room in house.

14"metal channel long ,5/8 channel deep , both ends have winds, 1-3/32,13-5stamp Is the product code S385-14 the correct piece to buy?

Need for 7 windows