Viewing all customer Discussions for:

Door & Window

I have a channel balance marked Fiberlux 24B. I used your website but didn't find exactly what I'm looking for.I'm attaching some pictures. Hopefully you can help me out.

We would like to replace a broken pivot bar for our window. We're unable to find any manufacturer info on the bar. Any help would be appreciated!

Hi, This is a 1/2" window channel which is 27" long. I cannot find it on your website. If you are able to identify it, please let me know. Thanks, Jennifer

am looking for a spindle that will fit a door kit 20269103 white.. number on spindle is 0264-0873 1. i am going to order one of your that looks like it only it does not have the x on the bottom.. if you have one pls advise.

Patio door legance II

I have several vinyl insert replacement tilt-in windows with twisted sash pins and shoes. The only part ID I can make out looks like R1658 on the pins. Any help figuring out the right make (if there is a substitute i could make work, that would be fine also). Thanks! -Jay

20-2 on balance

I have been in touch with Tim C via customer support email and was directed to send these photos to you. I'm looking for replacement glazing bead for a few Gapco windows. The measurements of the part is 3/8 by 6/8. I need approximately 166 inches of it - two 27.5 inch strips and three 37 inch ... (cont.)

I am trying to find a replacement part for an Atrium window channel balance. It is aluminum and 29" long with a 1/2" channel width. The balance is stamped 28 3 FU CMC 4 The windows were installed in 2001 but, according to many, Atrium Windows and Doors went out of business/bankrupt in Arizona year ... (cont.)

I need two sets of window balances and I am unable to locate them anywhere. Do you have these available?

The existing channel balance does not have a number stamped on it. Print info say " 29 3 HR CALDWELL" ? Does this relate to a specific replacement part. Sash weight around 32 lbs. Also have smaller Kinco window with 18" lower sash, with around 16" channel balance. Do you have that replacement pa ... (cont.)

33 x 65 installed 2003 stamped on balance 34C ml BSI Window manufacturer unknown I am also looking for a bottom gasket

need two channel balances for a no tilt window, channel balance marking is 28 4 EP Caldwell, metal length is 29 inches. I can not differentiate top or bottom shoe by examples in your website. Pics uploaded are top and bottom views (both front and side view)

Looking to R&R 8 windows. I need new balance channels for 8 windows. Manufacture is out of business (Jordan Windows). Metal channel is 28" x 1/2 " overall length 29" thank youJon

Trying to find replacement handle lock kit for this door? Any help would be appreciated. My handle measurements are 7 1/2 by 3 1/2. Would you have this in stock?Thanks

weathershield window 1993 old bal measures 31in long ,series 751 x 31in long .I weighted window 24# ,which spring load to use 30R 15/23 or 30 HD 23/29 also new type pivot pin can I use it allabout door #640023/640024

I need to identify and replace this part.

Looking for the lower piece of this window. Only need about 3 ft piece. Not sure of correct name of part.

Good Afternoon, I have Milestone Series 1000 Single Hung Impact windows in need of some new hardware. I purchased Series 372 channel balances from you in 2016, but these did not fit correctly. I've attached photos of the channel balance which carries a code of LB 28F. In addition, I've attached ... (cont.)

Not sure I see this lever awning operator on your site? Thanks, Todd