Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

Hey, I'm looking for a full crank assembly for this window. If you look at the crank itself the metal part that the handle attaches to to open the window, it doesn't open or close past a certain point, and you have to either pull on the knob and unscrew it or push on the knob and screw it in order t ... (cont.)

Are you able to assist me with this hardware? Your help is much appreciated Thank you Victor

It seems the gear is stripped and will not open or close correctly. The part number looks like 45136 with a pat # 4505601

Part is stamped RH. 9.5" arm. Down offset. 3.0" x 1.5" (center) holes

Think I need part numbers 39-413 and 39-348? If so do the clips come on the sill mounted operator? Should I replace the shoe studs? What are the dimensions of the crank body as I measured in my pictures? Are they the same?

I need 4 each of left and right operators for eight casement windows, and eight fixed (not folding) handles in bronze

Dear Swisco, I am seeking replacement hardware (hand crank, worm gear, bracket, and toothed lever arm) for a Patriot brand kitchen casement window. The spline for the hand crank is stripped and the worm gear / toothed lever interface is also stripped. The two photos show the spline and the visi ... (cont.)

Do you recognize this part? If so, what do you recommend as a replacement? Please review attached photos for hardware identification Thank you Joyce

I am trying to locate a control that looks like the one pictured. It measures 11" arm length from the center of the gear crank to the center of the bearing at the end of the arm. This one mounts with screws from behind. Is this a product you have?

Looking to replace the crank hardware for 2 windows

I've seen other operators with 4-5/8" pivot arms. Ours has a 9" pivot arm.

We would like to replace our casement window operation. We've attached photos with measurements. Which replacement operation should we purchase?

Attached picture is from my casement window. House was built in 1992-94. Windows I believe are Semco but there are no markings. Can you tell me what part number this might be, so I can order a few? THX R

Hello, I have a casement window in the kitchen and the handle is broken. The handle assembly part # OP05-7554-03. Could you please let me know how to replace handles for both window panels? Thanks Manju

no name on window hardware has number 21550 also the word truth it is a double casement with stationary center pane

Hi, home was built in 1986, I believe these Coradco casement windows to be original. Need 12 left hand cranks and 6 right hand cranks. Thanks.

I have 9 screw gears that are stripped, it will only open the window but not pull the window back in. I have 6 plastic covers that are broken or missing. I need 3 handles because they are missing from the Windows.

Trying to figure out which operator this is. The crank has stripped and it appears the socket is rounded out too. Picture is of the right hand, I need the left hand operator. It says Roto on the mounting plate. Thanks, chris

Looking for replacement casement window operators

Good Afternoon. I am looking for a replacement window crank operator. My previous model was by Wright. Dimensions are as follows: Base is 4" wide and 3" long. Length of moving arm is 9". Holes for screws must go downward into the wood. This is a right window crank.