Viewing all customer Discussions for:

39-155 Caradco Window Crank, 9-1/2"

These seem to be K K casement windows. Crank handle seems ok, I have some spares and they exhibit same problem. The gears inside the plastic housing seem worn. The metal is very soft, I found them packed with a very thick grease which I cleaned out for photos. The screw in the handle is a typical ... (cont.)

Hello, I have a semco window to repair. I believe the following applies to my window: Left handed Dual arm Surface mounted Detach clip on one arm Roller on one arm Stamped: Truth entrygard 30350 Do you have a correct replacement. it seems that I must remove a wood piece to obtain access to the ... (cont.)

I need to replace the operator in the above photo. The following numbers and names are stamped on the operator in various locations: 40254, 30710, 20544, EntryGard and Truth. I believe the operator is a 39-031. Please confirm that part number is correct. Thanks in advance.

Good morning, Attached you will find photographs of when the chronic operators I am looking to replace. There are a total of 4 windows to right and 2 left. If you need additional information please let me know. Thank you

Good morning! We are renovating an old church and they have Garadco parts. What do I need to do to replace this, or what items do I need? Any help would be appreciated! Thanks!

Per my contacting your customer service regarding the two window handles received and the one that is an incorrect fit, I was advised to send comparable photos of our current closer with the one that was sent. Attached are the pictures and order info. The two operators were for the same window uni ... (cont.)

The arm of the casement window operator keeps falling out of the window sash. It is a left-hand window. The length of the arm itself is 9 inches. What do I need to order to replace it?

I measured and the short arm was 3 3/4", long arm was 9 3/4, track was 11 3/8 with 4 screws so I was able to find that. From the outside, ash shown in pictures, the window opens to the right. What operator should I use?

Looking for a left and right operator. Cover looks like a truth operator. But one of the arms has like a "S" curve in it. Please see pics.

Hello! I am trying to figure out what hardware this is, the chrome is pitted and I would like to replace the chrome items with a bronze to avoid a repeated pitting in the costal condition. Can you please help me identify this hardware? Some of the windows have a truth logo on the armature, but I can ... (cont.)

Lincoln Window. Gut of crank seems to be stripped. Cannot close window must manually push shut to close and lock window. Extended double arms measure approximately 17 inches. (my best measurement) Thank you for your assessment!Alice

Hello,The cylinder broke off of my Nuprime window hardware and I'm hoping to find a suitable replacement. The base plate is 2-1/8" x 4-7/8" and the arm lengths are 3-1/2" and 8". The color is beige. Can you provide me a suitable replacement for this?Thanks,Jed

Hi. Can you direct me to the correct part? I think I need at least three handles. I am not sure if I need the actual crank until I get in there. Are parts returnable in case I overbuy?

Hi, Just wondering if u have the window arm EntryGard TRUTH / 31538A in your store. Thank you Roopan

These are photos of a working assembly. I have several assemblies that are rusted which causes the window to deform out of square when open and close incompletely. The lower post/hinge of one is rusted through. Thank you Mike

20810A

Hi not sure what model I need for this.Can you identify should be a right-hand crank i believe.#30710 number on the body and #20755 is on the clip armThank-YouBill

Hi! Trying to replace these! I measured and want to make sure to order the right parts! Thank you!!!!!

Window will let out but want retract. Handle just turns out of the crank.