Viewing all customer Discussions for:

15-111 Pivot Shoe, 1/2" Thick

Need Left and Right Coil Springs Hardware shown in the pictures for 6 windows. Label picture is from one of the windows.

THe ribbon spring is 1/2 inch wide.

elongated 3"-4" length

Greetings! I am in need of parts for my tilt windows. I will need each of the separate parts in the photos but I am unsure of the part numbers, measurements, etc. The pivot shoe has a patent number 4,610,108 stamped into it. It measures approx .5"x 1"x 1.25." It has two (balance) coils as shown in ... (cont.)

No printing on metal coils or plastic piece. Both coils have snapped, but other pieces seem fine.

Trying to ID the upper portion, the tilt shoe, and the spring, or help me determine how to better ID the spring we need for this unit. Thank you...

Window balance sash

THE COIL BALANCE PIECES ( BOTH ) IN PHOTO ( FRONT) # 1 AND (BACK ) # 4 ARE 1.25 INCHES WIDE THE WINDOW HAS NO BRAND NAME ON IT- PHOTO # 2 - DOUBLE HUNG VINYL CLAD. THE COIL HAS PRINTED ON IT # 7.5 - 31 " THE TOP PLASTIC PIECE PHOTO # 1 WHICH HOLDS THE COIL HAS PRINTED ON IT - PATENTS 5.232.208, 5.36 ... (cont.)

Window ballast Springs are broken as shown in pic 2 and pic 2 I have not seen any numbers or markings on the window It is a single hung Window The lower panel is 17 inches in high (pic 3).

I order the wrong part for my window this is what the installer says I need. Also can I return the parts I ordered.

this is one of the balancers, the spring is stamped 7.5 31" and a number 52323.the window weighs 14.1 lbs, measured it on a scale. I believe the spring can be replaced with a 160?.I will need 4 of each part listed , just want to make sure I'm getting correct parts. parts required. 4 7.5 lb springs ... (cont.)

See photos...hoping you can assist in identifying the correct replacement Tilt Window Mechanism for these Simonton Windows. We have several in need of replacement. Thank you

I'm a contractor trying to fix a window for customer, but I can't tell what size of coil balances I need. They are the type like your Series 196, but I cannot read anything off of the springs. There are 2 springs, piggy backed on each side, so I need one long and one short. The window is a tilt-in ... (cont.)

Hi, I am looking to replace a Milgard double hung window balancer. Photo attached. Do you carry this part?

I need a few of these

Trying to identify if the lower balance shoes are available. The top stops appear OK. We have not removed the sash channels the see if anything else is broken. If only the shoes are broken, are they replaceable without removing the sash channels?

Good Evening, A couple of my double-hung window panes fall down when unlocked (top pane) or don't stay up/open (bottom pane) and it appears that the pivot lock shoe is missing on some and damaged on others. Attached is one of the window's label as well as the part needed. Your assistance in identif ... (cont.)

Can someone help me identify the part number for the spring and pivot show in the picture

Please help me to identify the these parts for my window assembly. Attached pictures shown are existing parts. I need to replace these parts. Also send the name and address of local dealer who carriers these parts.Thank You.

Good Morning, I need to replace a few Simonton double-hung window balancers. The spring section, at top of the window track, has two units, each fastened with two screws, with the lower spring unit slightly longer than the top spring unit. I'd like to obtain the parts to replace the entire balanc ... (cont.)