Viewing all customer Discussions for:

S351-24 24" Series 351 Channel Balance

Could you provide the item numbers for the bottoms and tops for the Yale-Ogron channel balance ends?

I have no number stamped on the any of my balances. I checked all three windows. I think it's either 351 or 391. They look the same in the pictures.

This is a new question. Good afternoon. I want to order the correct 1/2" channel balances and parts for my windows, but identifying some of them is a little tricky. The house was built in 1979. The balances look like either the 351 or 390 series, but i can't tell for sure. The lengths are 24" stam ... (cont.)

I need 8 channel balances and 10 clips. Number stamp is 2350

I have a channel balance of unknown origin that matches the S351-24 series but it's stamped 23A, please cross that to your weight code.

Do you make a need 24" counter balances with a 19-005 top and the 15-002 shoe. On my last order I purchased the S351-24 and then had to order the 19-005 tops separately and install. If you do what is the cost and the lead time? I need 12 pieces.

I'm needing to replace a couple of channel balances for a window. The balance is stamped 23D. It is 9/16" wide which I have read is considered 1/2". Based upon using your selection tool, I think I need something like the series 351 24" 2340 channel balance. But one of the ends look more like 15 ... (cont.)

I just received the parts, S351-24. Upon Inspection I realized I made a mistake in identifying the proper Channel Balance and the top piece is not correct. When I went back to your website today I could not find a match with the proper top and bottom. I have attached two pictures of the top piece th ... (cont.)

Good morning, I was trying to order some parts to repair my windows channel, but the only thing I can get is the number on the channel and the length. The parts are in such a bad shape that if I take a picture of it you can only see pieces of it. Is it possible that you can determine the type of t ... (cont.)

I have several windows about 32x51 in size that need new balances. The sash weighs 15 pounds. The existing balance is 24" long has the marking 23 B and the BSI marking. I'm pretty sure that the balance I need is part S351-24 but I don't know if I should order option 2320 or 2330. ... (cont.)

I have a 12" balance on each side supporting a window sash with a weight of 6.4 lbs. On another set of windows I have a 24" balance on on each side supporting a window sash with a weight of 16.9 lbs. These balances do have a stamp, although one side says 2320, the other side 2330. Shouldn't the ... (cont.)

I have S351 Balances with 2310, 2320, 2330 option numbers. These are old windows and the parts may have been replace before. What is the difference between the different option numbers

We have single hung non-tilt aluminum windows. Most of them are very hard to open. There is a lot of tension perhaps. I pulled out the channel balance (part number S351, 24")and everything seems in order. My question would be why is to hard to open? does the spring get harder/more tension over time? ... (cont.)

can you tell me if you have this part,need to order window balancer and top sash but can't figure out the part # for top sash

Can you please help me identify my channel balances? All the ends are the same. Just different lengths like the pictures I sent yesterday.

Need replacement spring assembly for Kinco windows. This would be for the balance channel. The springs are rusty and the cords are dry and have given up their elasticity. Also, the plastic tops have been destroyed by the extreme heat from sunny days. Also the pulleys have been dried out and have bro ... (cont.)