Viewing all customer Discussions for:

S380-24 24" Series 380 Channel Balance

Hello I need help determining what window balance part I need to order to replace this one. I believe there's supposed to be a spring inside that is gone. Thank you

I have a 24 inch, half inch wide channel balance that needs replacement. It has 23 5 pd BSI stamped on the side. Can you get a part number for me. Thanks

23 4 jw cmc 11 I measured it and it's 24".

Bottom shoe is exactly 7/8" deep

Hi there, I'm looking to replace my daughter's bedroom window balancers. The only numbers I can pull off of it was BSI 23 9. I believe the channel measures almost 24" maybe 23 5/8ths and the width is 1/2". I should have taken better photos but this is what I got. Any guidance would be greatly apprec ... (cont.)

Can you pls assist to let me know which part I need for my window. The Length is 24" long. I added 5 pictures for your review. Also, the item states 23-5 IX CMC 7.

Hi I need some new window channels for my Marvin windows, one of them the string has failed and the others are really hard going up and down. I need 2 2330R, and 2 2030R replacements. Hopefully the pictures should be enough to get me the right parts. These are all the wider channel widths I think ... (cont.)

I need 24 of them.

2340 J stamped I think it is your part S380? Please confirm.

This window balance is from a Window Master Window. Not sure which replacement to select. Could you help. Thanks Much

the sheet metal extrusion is 24" long

I need 6 sets of this item. It says 23 3 HK Cadwell on it. they are 24 in metal to metal. Can you help me. I am a senior and selling my home but need to repair my Alpine windows installed in 1990. Thank you

I think I have a 24" channel balancewith 2320 stamped on back. It looks to be a S395-24. The top of the spring looks like it attached lower down than the photo on the 24" Series 395 Channel Balance page.

I need to identify soma block and tackle parts in order to buy them! See

Hello, the Window Channel Balance is 24 inches long, 1/2 inch wide and has a stamp of 2340 on it. Thanks for your help. I would like to replace them.

There is no name on the channel balance. The mark I found on the channel balance is 23C USB. One of the channel balance top is broken. I attached the marking photo, 2 photos for top and 2 photos for bottom connectors. They are top and bottom view of the connectors. Please advise what the replacemen ... (cont.)

Hi there, i have posted 5 pictures of the item i needed, hoping for your earliest response...thank you

I think i need a s380 or s385 non tilt window channel balance but not sure. It's 24" 2320. Please let me know. Thank you

I need to replace these balance rods:6 rods 2620 27 inches, 2 rods 2330 24 inches,2 rods 2940 30 inches . I also need ten each of the shoes and tops photographed here.

Window type is a Seasonshield Series 5500 spec. DH-C50/C60.Window weight 40 lb. 30" tall.Installed was the attached balancer stamped 2390 30. 24" long.Recently I purchased your Sash guides # 18-161 for the above window and during installation discovered some bad channel Balancers.Believe your S380 ... (cont.)