Viewing all customer Discussions for:

S380-30 30" Series 380 Channel Balance

Need to know which one to order please help

I need help in identifying the specific part number for this item so that I may order two of them. It is a block and tackle balance for a double hung window. Measured from metal to metal, length is 30 inches. The width of the channel (inside width) is a little over half an inch. It is stamped wit ... (cont.)

Need assistance with selection of proper part. Channel is 1/2" wide and 30" long. Thank you!

Hi Team, I am looking for a replacement part for the attached channel Balance. It is for Single Hung Window. The marking says "29 4 FV CMC 7" Regards Samir

Length: 30 inch (metal portion) Width: 1/2 inch

Looking for this replacement please help?

Please help me identify the following parts 29 5 GV CMC 2 29 5 FV CMC 7 26 4 HV CMC 7 Thank you

I need to purchase a set of these channel ballance.

Window Master vinyl window channel balance, Stamped into metal rod 2940 DL. Rod measures 1/2" wide; 30" long without the plastic piece on the ends. Thanks!

I need 2 balancers.Window is 64h x 40w Milguard. Sash weighs 25lbs. Balancer is 30 in long.

The stamped letters/numbers are 29 4 DX CMC 7

Looking for milguard balance Pic is of numbers on part and numbers on window.

Looking for these tracks. Need to replace ours they are old and windows are getting stuck. Would u have them in stock

I Need two balances, a couple of little square track guides, and a couple of the arched springs that go in the locking lifters (if that makes any sense.

Hi Swisco, Can you help me in find the correct window channel and take-out clip. My window channel has the number of 29-3-HV-CMC-7 marked on it. The lenght of the metal rod is 30 inches. The take-out clip is 1.25 inches. The metal rod thickness is about 9/16 of an inch. Thank you. I would nee ... (cont.)

Hi Swisco, I need balance replacement channels for 12 non-tilt windows. 1. 29" (4 windows) 2. 32" (8 windows)

Need to replace the 2 balance springs for bottom sash. Bottom sash weighs an estimated 40 lbs. Balance spring is 30". Markings on spring are 29 5 HV CMC 2. My phone # is 812-629-8806 Thank you, Mark

The Channel Balance Assembly is 1/2" wide x 30"long. It is similar to S380 except bottom shoe depth is 7/8". Top guide and bottom shoe are both winged. The top guide appears to be 19-005. The bottom shoe appears to be 15-029. The assembly is stamped "2920". Is this assembly a stocked item or a speci ... (cont.)

All, I'm having a hard time figuring out which part I need. Most of the windows that I have are of the same dimension. I took out one sash and weighed it on a scale which came out at around 17.6 pounds. I located a stamp on the block and tackle which was 930. Measured the length which verified at 30 ... (cont.)

I have a Balance rod with odd stamps on it. Odd to me anyway. It is stamped 29DS 48L. Now I'm assuming that its a 29 series, double spring? But I don't see a double spring in it, just 1. Amd a sash weight of 48lbs. I wanted to verify all of this. Plus I don't see double spring balances on your sight ... (cont.)