Viewing all customer Discussions for:

21-152 Floating Grommet, Float-A-Way

I live in Florida, do you deliver?

Need to find floor track and top pin for 3 bifold doors

here is my problem. i have 40 year old metal bi-fold doors in all the closets. they are bolted together so they swing open like a regular door, so i don't use the pins on the mating edge of the doors, only the outside edge. on one door only, i can use the slot on the bottom pin and raise the door ... (cont.)

Have a lot of pins and grommets needed to fix 10 closet doors

I am needing hardware for a project that we are working on. They are metal louvered bifold doors. Needtop and bottom hardware for 1 set. I have attached pictures of each. I estimate the home to be built in the 1920's but not sure when the doors were added, possibly original. Any and all help would b ... (cont.)

Hi Ron looking to rebuild how thanks.

Hello, I am looking for replacement parts for closet doors which I had to remove for a construction project. I would prefer if there is an easier pin to use than the ones I have in the pictures. Also there is a stopping block in the bottom rail that is missing and I would like to replace it and th ... (cont.)

Hello Do you have replacement hardware for this bifold door? It's super old, date on back says 1971. Neither door set had a complete set of hardware on it. They're in an old mobile home. Hoping you could help with the upper and lower pin replacements. Also not sure the tracks have the pieces they'r ... (cont.)

Hello, I got these grommets (21-163) for my bi-fold doors, but they don't seem to fit the guide pin. Is there a bigger size available? Thanks in advance!

I am looking to replace the tracks, pins, and all other hardware for all the closet doors in the house my wife and I just purchased. The house was built in 1958 and has the original closet doors, and we expect the original mechanisms. I have had a really hard time identifying and finding the parts t ... (cont.)

Metal pins are fine but need grommets with inner hole diameter 5/16" and bushing inside diameter 5/16" and pin cap 3/16" inside diameter and come spring 2" high , 5/16" and 3/4" diameter. I will send additional photos to make sure parts will fit. Also are there any videos on best way to insert long ... (cont.)

Dear Sir,We are doing renovation on multiple apartments with older metal bi-fold doors. The hardware for most of the doors needs to be replaced. I have attached pictures of one set of doors and the existing hardware. I do realize that most of the nylon bushings are missing and the pin in picture #14 ... (cont.)

I am renovating my place and decided to spray paint my old closet doors, unfortunately once I removed the doors the top pivots came off and the little plastic plugs are no longer keep them from springing out. I will need to order new top pivots and bottom pivots along with additional stationary pivo ... (cont.)

hi , i need to buy the plastic parts for the bottom and top of the door , see attached picture thank you

I need about 6 of these guide pins so I want to make sure I get it right. Can you help identify the correct pin? As you can see from one of the photos, the current pins (or the broken pins) were 4 1/2 inches long. These are metal doors, fairly old in my estimation. I'm sorry that some of the photos ... (cont.)

I need 6 or so pin caps as shown in the pics. I need only the cap. The shaft that the pin cap goes on is 5/16 diameter. I believe the cap is 7/16 tall, perhaps a 1/2 inch. The bottom of the cap ( the larger ring) is 1/2 inch. If you have a cap that will fit my pin shaft I would appreciate your r ... (cont.)