Viewing all customer Discussions for:

S795-36 36" Series 795 Channel Balance

I need replacement kitchen for 36inch tilt windows.Kindly get back to me with the type of parts I need.Thank you in advance for your courtesies.Tim

Looking for 8 of the 38c and 6 of the 36c Thanks to all for your service

Hi, I am looking for a set of (8)balancers 38c with tilt and (6)36 c that tilt in All are squared body Thank you for your assistance

I am trying to figure out the model of this window balance. Metal to Metal Length is 36 inch. Width is between 1/2 and 5/8. It is a plain balance with a metal hook in thr top and and shoe on the bottom.

Hi everyone,I have this balance it's exactly like series 795 channel balance I was read all the customer questions about it and I noticed that this kind of hook needs to be custom, so I need 22 of them.The length is 36C and I will send you a couple of pictures for the shoe size.And I need 2 balances ... (cont.)

In need of these replacements.

Hello, I have windows that are either stuck closed with balance disconnected and up in the top part of the window or windows that just wont stay open. In some cases the clips on the bottom sash are broken. I think I need to order new balances or new clips or both.

Two Patriot windows have broken sash and cannot fully open. Originally installed in 2004 by home builder Pulte.

Two windows need new balances. Larger window balance is stamped 36C. Smaller window balance is stamped 36A. I have confirmed both are 36" long minus the mounts at the ends.

Hi trying to identify replacement part(s) for 20 year old double hung tilt out windows. Looking to replace the whole channel balance unit. Stamped on side 36 C BSI Thanks

Hi there I'm looking to order 3 sets of channel balances for my 20 yr old Patriot windows. The balances have 36B stamped on them and they measure 9/16" wide and 36" length. Thank you for your time. Please let me know if you need more information. Thank you!

I have 6 windows where the old balance clips that attach to the springs have broken. My existing balances are 36" and say 36C BS1 on them. I assume I would need the 795 Balance 36" long. My existing cams are Open cams 1 1/4" shoe width. My exitsting pivot bars are the same measurements as the 26- ... (cont.)

Hi, I need the inverter and channel for these parts the existing channel is 36" in length

Hello, the 36" Series 795 Channel Balance seems like the right fit for my window. However, the current balance is stamped as 36F. Can you please let me know if 36E is compatible with 36F? If not, what would be a good substitute? Thanks, Haider

Concerned on how to get bottom fitting into the frame. 9/16 X 9/16NV Home windows from 2008Thanks Steve

Hello,Wondering if you can help with this. I would like 4 new balances and the little plastic connector. Let me know if you can help. Thanks, Eric

Hi, I need to replace a few channel balances on my windows. Looking thru your site I think they are the 36" Series 795 but I would like some confirmation. The balance on the window are 36" long, measured as the photo on the 795. Thank you, Robert

Trying to find the balance that will work for a sash weight of 39.9 lbs and a glass height of 35 1/4". The S795-36 has the correct dimensions as far as channel width/depth but the weight doesn't match. I don't have any pics due to the window not having balances to remove

Please see attached pictures I need a replacement partI found this below link which recommends S795-36 and 15-194 https://www.swisco.com/discussions/Replacing-Window-Channel-Balance-77-100663Added more pictures

Looking for replacement channel balance - block and tackle for 1800J series single hung window