Viewing all customer Discussions for:

26-378 3" Pivot Bar

Please ID the Tilt Pivot Bar. It is 3" long.

2006 Charmatt Window hardware for double pane tilt window. See attached photo of broken part. Could be a pivot bar?

Do you have any of these?

Ordered replacement sashes for some of the windows in our house and the pivot arms are not the same. Checked with Wincore and got nowhere. I need the ones on the left. Can I buy a dozen of these somewhere?

Have a single hung pull out window with two broken T head pivot bars. Looking for correct replacement parts as well as advice on how to remove the remainder of the broken pivot bars still located inside of the casing.

I have a ten year old Simonton Double Hung vinyl window in which the upper unit has failed coil balances and on one side the pivot bar has broken and a missing sash vent stop. I'd like to acquire the appropriate parts (replacement pivot bar(s), balance springs and while I'm at it, probably good to ... (cont.)

Hi there, I have a broken pivot pin at the bottom of a sliding window. Unfortunately I can't find a label attached or any other labels with the manufacturer of this window. I have some photos and on one of them it looks like at the bottom of the pin it says 17. The pin has this little extension that ... (cont.)

I don't know the manufacturer, but very likely Canadian, as my home is a modular home, built by Royal Homes in Wingham, Ontario. No markings or numbers of any kind on the part. The home is only 17-years old, but several of these have either broken or have been pried out from the windows -- mostly ... (cont.)

Please if you guys can help me ID the coil balance and the pivot bar that goes with it? greatly appreciated!

I need the weight balance hardware foe 12 of my windows. This is one of the smaller ones.

I am searching for a window pivot for a Simonton window. On another website I found a photo and description that gave me this number

This broke when removing from window! What's it called and can I get a replacement?

I need 6 of the complete coil spring covers the springs are good the plastic is destroyed.I also need 2 of the T-Hangers that screw into the window.I need the smaller set up but I'am sending you a photo of a larger window one image 5215 to help you in figuring out the model of the windows the ones I ... (cont.)

This picture is the broken ends off the bottom of my double hung windows (Simonton). I have had them for about 5 years now and need the replacement parts so the window will stay up when opened.

Doing some repairs at a home. I need 2of these pins

Looking to locate replacement part for window due to pivot pins breaking. Pin is 2-1/2" long with hole 2" from T-head. Offset in piece is 7/16". Can find similar straight replacement pins but none with an offset. I have 18 similar windows and looking to purchase replacement pins for all. Not certain ... (cont.)

Hello, I am looking to get some parts for my Monton window. The window right now will not stay up and upon inspection the window is missing the peg that goes in the side the latch mechanism that holds the window up. It looks like there are screws on the bottom of the window to be able to replace th ... (cont.)

I just replaced coil balances and covers on a few windows and discovered I had some broken pivot bars. I cannot match the bar I have with one of yours. It looks like 26-241, but the tip is shaped different and is only 3/8" wide and my tip is 9/16" wide. Then I compared 26-378 which looks like the co ... (cont.)

The window weighs 18.8 pounds I'm needing two of them and pivot bars

3 in with two screw holes. Slides in bottom of Simonton window made in what looks to be 2004