Viewing all customer Discussions for:

S385-26 26" Series 385 Channel Balance

The spring and cable won't extend seems to be stuck and won't move. Looks like one of the plastic guide wheels is broken cracked and jammed.

I have one of the windows with two locks. It is not going down. I need to know which channel balance I need to replace. The length of channel balance is 27 inches. Please advise. See attached picture of window and old channel balance

The cord broke on the balance on the right-side of my window (looking at it from the inside fo the house). As shown in one of the photos, it says 25 4 LJ Caldwell but because the house was built in 1978, I don't know if it is still available.

This clip is used on certainteed windows installed in 1998. We could use at least a dozen of these because they are all brittle and breaking.

The balancer is 1/2 inch wide and the metal is 26" long.

I need 2 replacements.

Width is 1/2 inch lenght is 26 inches marking has 25 3 CS Cadwell on it

Hello! After a lot of research I purchased two new window sashes, 26" Series 385 Channel Balances, but I suspect I was wrong. The 26" part is correct but I think the spring is too strong. My sash only weighs 18.2 lbs. Attached are photos of the old sash. Can you help me ensure I have what I need? ... (cont.)

See attached photo with the stamp channel width is 1/2 inches length of the metal channel is 25 inches pl help in identifying your part # to order pl help thx Rakesh

25 4 bx cmc 11 This is what is printrd on my ballancer.. Thank you Leo

Single hung window balance spring broken, it reads: "25 5 AX CMC 1" on the side of it please let me know which one to purchase. Thank you.

Looking to replace a block and tackle channel balance. Please see attached photos. Windows are approx 20 years old.

How can I tell which 27" channel balance part number to purchase? I see you have at least two model numbers

Current balance is 1/2" x 26".

Window balance with markings: 25-5 BV CMC 1

Hey there, I'm sending pictures for the balancer in my window. At the back I can see numbers 2540 and letters BH1 (or BHI) and PH. The metal section of it measures 26 inches. Can you please help me to identify which one should I order? Thanks, Emir

Need help finding the right one for my windows. 26" long / measurement without the plastic parts and has 2540 on it. 2 1/2 inch wide

I need to replace a channel balance. Part is marked: 25 4 KO Caldwell. The metal chanel length without the plastic parts is 26" and the channel width (inside opening) is 1/2" and outer width is 5/8". I have replaced in a couple other windows but can't find the email with part number. Thanks. ... (cont.)

Metal channel is 26 inchesBlue letters 25 5 GV CMC 2Certainteed Vinyl windows installed 2002One is broken, but I better get 2 to be sure.

I need four or these. They are 27" end to end. The metal section is 26".