Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

Please let me know which replacement balance would be best for my window. The current channel balance is 27" long.

The metal part of my balancer is 1/2 inch by 27 inches. The stamp on the balancer is as follows: 26-3 DD5 CMC 87I have included pictures to help you with identification.

Please help to identify this 27" sash part # so I w could purchase 6 from your website. Thank you!

Hello there, I ordered six S385-27 tracks based on the length of the ones that were broken but, they ended up being an inch too long so they don't work, the hook in one of your tracks snapped off in my hand, the knot holding it was not good.One of your representatives said that I need a different tr ... (cont.)

We have KINRO windows that new the balances replaced. The balance have 26-4 stamped on them. The balance shoe is 1 3/32". From your help with others it looks like I will need a S385-27 Balance. I have included a picture of the Top Sash Guide, it looks like a 18-171? And I would like to order severa ... (cont.)

Looking for a replacement for a 26 3 CS Caldwell channel balance. The bottom attachment is marked 15P102 3 S

I am looking for replacement channel balances for my Milgard windows. I've attached photos of the original balances. Here is the text stamped on the inside of my window: May 17, 2002 - MM-CH 031168 004. The window panes these balances connect to are 29" tall x 33-3/4" wide. Could you please advis ... (cont.)

Hello! I could really use your assistance to determine the correct replacement balance for my windows. I have multiple windows that are completely missing balances and some that have failed. This is one of the failures depicted. The other windows are the same size as the one this balance came off o ... (cont.)

need balances

Looking to get replacement balance rods for my Milgaurd windows 1989 vintage. Metal piece measure 27" long w/o the plastic guide ends that are riveted to it. Spring length is 12" long approximately 5/8" wide and 3/4" tall Thank you,Steven

Hello?.can you please tell me the correct balance to order according to this picture?.I provided My part says 26 4 AU CMC 4

Numbers on it says 26 4 jw cmc 11

Looking for a recommendation for a replacement channel that is stamped 26 4 HK Caldwwell. with the photos i have uploaded, i believe i need an S380-27 with 2640 option. Please review and advise.thank you,chester

1/2 inch channel. 28 inch long. Milgard sliding window (non tilt). 26 6 fx cmc 11. Likley 2005-2006 manufacture. Photos & label. Thx.

27 inch channel length. 26.5 JR CALDWELL written on the side of channel. 4 balancers required total.

AMSCO VINYL WINDOW

Hello - I am looking to replace a couple of Milguard window balance's. I have attached a few photo's. The balance is 27" (metal end to metal end) and 1/2" wide. Thank You

We need to replace two channel balances in the same single hung window. The channel is 27" long without the attchements (metal channel only) The only stamp I see on the channel is 2640 BSI

Hello....you helped me with one last week. This 27 inch one has no markings.

Hey guys, I have to replace multiple window guides. I have attached several photos hopefully they will be sufficient. Looks like the metal channel measures 27". Your help in making sure I order the right ones will be greatly appreciated! Thank you, Josh