Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Hi can you help me find this part ?

Hello,Could you please help me to Identify balances, which I measured as 1/2 inch wide and 30 1/16 length.Also does it come to be assembled with spring nylon cord and all plastic items attached?What is the turn around time to FL?Thanks

I would like to replace the subject window channel balance. It is stamped 2930, the actual channel is 29 3/8 inches in length. I would like to replace both sides. It is a 1/2 inch channel

Channel balance measures 30" metal (not including top and bottom nylon pieces) Windows manufacturer is Kinco Do you have a replacement part (please advise if more pictures are needed)

Need to know which one to order please help

I need help in identifying the specific part number for this item so that I may order two of them. It is a block and tackle balance for a double hung window. Measured from metal to metal, length is 30 inches. The width of the channel (inside width) is a little over half an inch. It is stamped wit ... (cont.)

Need assistance with selection of proper part. Channel is 1/2" wide and 30" long. Thank you!

Hi Team, I am looking for a replacement part for the attached channel Balance. It is for Single Hung Window. The marking says "29 4 FV CMC 7" Regards Samir

Length: 30 inch (metal portion) Width: 1/2 inch

Looking for this replacement please help?

Please help me identify the following parts 29 5 GV CMC 2 29 5 FV CMC 7 26 4 HV CMC 7 Thank you

I need to purchase a set of these channel ballance.

Window Master vinyl window channel balance, Stamped into metal rod 2940 DL. Rod measures 1/2" wide; 30" long without the plastic piece on the ends. Thanks!

I need 2 balancers.Window is 64h x 40w Milguard. Sash weighs 25lbs. Balancer is 30 in long.

The stamped letters/numbers are 29 4 DX CMC 7

Looking for milguard balance Pic is of numbers on part and numbers on window.

Looking for these tracks. Need to replace ours they are old and windows are getting stuck. Would u have them in stock

We have 22 WindowMaster windows that we need to replace balancers in them. We bought this house a few years ago and many of the windows cannot even open anymore.Pictures above are what the top and bottom pieces look like.CAN YOU HELP us identify which parts to order? We weighed and measured every ... (cont.)

I would like to know where to go for spare parts here ...

Hi can you help me identify the correct balancers. 1st is 26-4 AA CMC 7 metal length is 27". 2nd is 29-4 KX CMC 11 metal length is 30". Winged channel balance shoe appears to be just larger then 1 1/8", and the metal slide appears to be 5/8" on the open ended side and 1/2" on the opposite side, and ... (cont.)