Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

I Need two balances, a couple of little square track guides, and a couple of the arched springs that go in the locking lifters (if that makes any sense.

Hi Swisco, Can you help me in find the correct window channel and take-out clip. My window channel has the number of 29-3-HV-CMC-7 marked on it. The lenght of the metal rod is 30 inches. The take-out clip is 1.25 inches. The metal rod thickness is about 9/16 of an inch. Thank you. I would nee ... (cont.)

Hi Swisco, I need balance replacement channels for 12 non-tilt windows. 1. 29" (4 windows) 2. 32" (8 windows)

Need to replace the 2 balance springs for bottom sash. Bottom sash weighs an estimated 40 lbs. Balance spring is 30". Markings on spring are 29 5 HV CMC 2. My phone # is 812-629-8806 Thank you, Mark

All, I'm having a hard time figuring out which part I need. Most of the windows that I have are of the same dimension. I took out one sash and weighed it on a scale which came out at around 17.6 pounds. I located a stamp on the block and tackle which was 930. Measured the length which verified at 30 ... (cont.)

"29 4 JV CMC 2" is printed on the channel balance. 30" is the length of the metal portion only of the channel balance.

I have a Balance rod with odd stamps on it. Odd to me anyway. It is stamped 29DS 48L. Now I'm assuming that its a 29 series, double spring? But I don't see a double spring in it, just 1. Amd a sash weight of 48lbs. I wanted to verify all of this. Plus I don't see double spring balances on your sight ... (cont.)

Picture of 30 inch channel balance and top sash guide. They are lawson window from 2005.window size 30 x 51 weight 38 to 39 lbs. And other window is 36 x 34 weight 28 to 29 lbs.

Need help identifying this part.

Hello, can you please help identify which balance I need. The measurement is 30in. The print on the metal looks like 29-9.

I am looking for 2 replacements for this window

I have one that is operable and the other one is broken. I would like to make sure I am ordering the right part. Any help would be appreciated. It is printed with 2930 But I am not sure if I need a 5/8 inch or half inch guide. Thank you for your help

Windows balances 29-5 dh5 cmc 75

Hi there. I'm in need of the following parts for my windows. The only other information I have is that it is a 2930. Any additional help you are able to provide is greatly appreciated.

I need to replace this Do you have these The metal is 30" long 9/16" deep 11/32" wide

Channel is 30". I'm thinking series 385 30". Just need to verify. Thanks.

Need two

I needs replacement challer balancers BCI2940,along with top window sashes and window stopers

I will send additional photos

Please help me to order the correct part. Length is 30 inches. Thank you.