Viewing all customer Discussions for:

26-021 Pivot Bar, 2-1/2"

These are out of a milgard series 350 window installed in 2007

I have watched the video. It tells me that I need 24 inch series 795T lock 2 26-200 screw clips. my sash weighs 15 pounds my t-shoe one and a quarter inch My pivot bar is one and a quarter inch between the holes. I'm not sure whether it needs to 26-021 or 36-366

I need the pivot bar for a Model 714 Atrium 200 Single hung vinyl window. Existing bars have rusted so badly that I can't remove them without destroying them.

Pivot shoe measurements 9/16" deep , 1 5/16 wide, 1 7/16 high Cant seem to find a shoe with the 1 7/16 measurement, but does that matter?? Windows approximately 22 years old Replaced a couple pivot bars (26-021) 7 to 8 years ago. I am capable of doing the work, just want to make sure I get correct ... (cont.)

I need 10 pic. 29" I can't find this balance

Hello! I need 1 set of the latches 4 metal pivot bars And the part the window locks into? About 12 Do you have these parts in stock and how soon would I get them? Need soon as possible for inspection. Thank you

1ea. Block and tackle, lift assist 3ea.window tilt latches,right side 3ea.window tilt latches, left side 1ea. Pivot bar Note sticker for window size

Hi, I need 4 of these parts for my windows. Thank you

Hello, I needed a replacement for Unique 26 C 30 balancer. The string broke on the one in the pictures. Please let me know if you have a compatible part. The window pivots to come out. Thanks, Mark

Looking to ID this to find a replacement. Channel is 34" long Stamped 34C BSI AH The top Part of the channel was screwed into the top of the window channel. I didn't see any plastic piece or remnants of a plastic piece for the top part. Nothing was connected to the bottom on the broken side. Is t ... (cont.)

I'm looking for these replacement parts also I have included the window lock but I need the keeper to that will work with that window lock swisco needs to fix there system it only allows you to upload 5 pictures at a time

Looking for window replacement parts. Single tilt window. 28 D balance. Window was installed in Nov 1999.

Hello, I need help identifying the channel balance and the pivot rod in the attached pictures.

Looking window spring, shoe and piece that connects the window to shoe Thanks

Hello, I have to replace some of the counterweight hardware on a Mastic double-hung window owned by my landlords. I poked around and took the attached pictures. Please let me know which parts I should order! The counterweights are broken on both sides. Many thanks. Here are the photos you reque ... (cont.)

two holes pivot bar- please help to identify the right part for purchase

Looking for correct pivot bar for this sash. The current ones are non existent(rotted away). You have a few options that seem like they will work would like to narrow it down. Also a tilt latch. I believe I found 2 that will work. I never pulled the one off but not sure if based on the info if you ... (cont.)

My broken window pins are 2.5" and my balance is 25" and labeled 25b

This is a counterbalance for a mastic window, the length is 36 inches. The shoe comes to a point on the bottom side. it is an 1"-5/16on each side and in the middle It's an 1"3/8 long. It's an 1"1/4 wide and a 1/2" thick

Trying to figure out which pivot bars & balances I need for this window. Thanks