Viewing all customer Discussions for:

15-195B 1-1/4" T-Lock Balance Shoe, Open Cam

Chanel is 24" long 5/8 " wide 1/2" deep Numbers stamped on Chanel : 24B. B51

Hello Swisco--The 15-195B's I purchased are 1/2" where they need to be 3/8" in order to fit into a channel balance that is concave at the bottom end. Do you sell such a balance shoe. (See photo.) Thank you!

The piece at the end of the balance bar that the window hooks into

Greetings all .... attached are 2 photos .. the metal bracket that the shoe clips into has 2 markings 24C and BS1. I do not know if the shoe a closed or open cam. How do you identify this aspect of the part? Thanks for helping me identify the correct part. Appreciated ... Jake

20 7..... just 1 needed.

I'm looking for replacement bases to match the above for a Tilt Window with the above block and tackle system .

I Have a square window balance with a stamp of 32-1. From what I can figure it looks like it is a s795. None of the S795s in your online catalog have these numbers. The balance metal length is 33". It has an open cam 15-195B on one end and a 19-043 clip. Should I use the 33B or 33F?Thank you,Chris B ... (cont.)

Hi, looking for a window balance - left side it that matters. It's a 30", pulley style, on ply gem windows( not absolutely sure about mfg).

Windows will not open when I attempt to lift it up. Some of the window appears to have loose strings that connects to the channels

Hello,I have patriot 2800 series windows. I've been told they were bought out by Plygem but are discontinued. The slot at the bottom of the channel pulls out - seems to be only a crimp fit. Bottom of the window has the metal pins to fit into that slot for tilting application. Your S795 series see ... (cont.)

I need six of the balance's uploaded and whatever clips, screws, etc. that are needed for install.Thank You,Brax

The pin broke that holds the tilt lock on my flat channel inverted B&T sash balance part. The part is 30" long and the other sides are 1/2" each, and it's stamped with "308" and "JBSI" and the capital J is very small. The window has no name brand on it that I could find and is 33" x 64" probably or ... (cont.)

Need balance and accessories, and 2 pins. numbers on balance: 20 7 BSI

Looking for replacement parts for double hung window. This part, broken and missing top part attaches to the counter balance slider via a hook which has worn and weakened over time and acts as the hinge point on the window.

I have attached a photo of the balances in my windows. One has broke and many have so much tension that they will pop out next time I try to open the window. Do you have the replacement balance available?

Looking for inverted block and tackle single hung tilt window balance. Length is 36", part number on balance is BSI 36B, window BSL6 2862, 1700J 787743 003582730. Screw mount goes at top.

Please tell me what part I need and also my cam in old ones goes completely through cam other new ones did not I had to use the old ones thanks Jeff

Good Morning, I'm looking for a similar balance spring 26-7...picture is shown. Can you please help me in finding this? Thank you

Hi, These are the marks BSIN 32-3And it measures 33"Thanks Joe

Shoes are broken, block and tackle balance in good repair. Balance housing is 9/16" X 9/16". Casement channel is 5/8" deep, 1 1/4" wide with a 5/8" gap at the surface. What shoe do I need?