Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

Hello,I believe the entry guard dual arm operator is the correct replacement for my casement window operators. I need both the left and right operators. What do you think?Regards,Jim

Do you have available the opening and closing mechanism for a shoulder window? The mechanism has worn off a tooth in this will not open and close properly. I am attaching a photo.

The gears are stripped and so is the crank to the point the crank comes out

The part that I just received from eBay is obviously not the correct part. Can you please help me identify the correct part? looking at the window from the inside the crank is on the right and from the outside it is on the left so no doubt about it I (at the very least) selected the incorrect side ... (cont.)

I'm looking for truth entry guard dual arm operator. I saw a few on your site, but can't tell if they're the right size. The mechanism as a B on it and the part underneath as the numbers 31512 (both are visible in picture). The picture is of the operator on the window I can open?the one I need to re ... (cont.)

Dear there, I looked at your website, and found my window looks like casement window. Currently my window opener is broken (I can open the window, but cannot close it, the handle will be off when I close it. See the attached pictures. Could you please which parts I need to buy? Thanks a lot! Jon ... (cont.)

I AM LOOKING FOR THE PRICING AND AVAILABILITY OF THE PICTURED OPERATOR ALONG WITH THE BRONZE CRANK AND COVER.

need replacement

I'm trying to find a replacement casement operator any help would be greatly appreciated. On the straight arm stamped-30470 L.H.-On the two piece arm bent piece has -30841- stamped on it and the straight piece has -20510- stamped on it. I can't really make out any other markings. Straight arm is ... (cont.)

How do I measure the size and brand of operator so I can order new ones? They say "EntryGuard" by Truth.

need 1 operator LH arm length 9" need 1 lock on left side looking out

I need a replacement operator for a Semco casement window. The brand name "Truth" appears twice on the mechanism, along with a capital "L" and the number 31538. I hope you can identify the needed replacement part from this information.

we need to replace the whole gear mechanism. Thank you

I'm looking for new casement operators. I am not sure of the window manufacturer

Hello I believe that this is the entry guard operator, but not entirely sure, the arm is roughly 9" however I measured to the sill so the 10 3/4" to the center could be correct. please let me know,

I'm looking to replace this operator with something compatible where the handle folds flat rather than sticks out. Could you please recommend a compatible operator?

Hi, I just purchased the Subject part and thought I had the right one. All the measurements were spot on. But I overlooked that this has a downward offset. I realized I'm looking for one with the same measurements, but with an UPWARD offset. Do you carry them? If so I will need to exchange the one I ... (cont.)

Looking for this Pozza hardware replacement for a casement window....right handed facing the outside from interior. Need the complete fixture. Thank you. George

I'm looking for replacement arm and crank for this type of window - house was built in the early 80s

I am looking for this hinge crank for a small bilt best window about26-28inches. The stamp on the 10.5 arm is entryguard truth 30842R. Can u help with the info I have provided?